Yamaha EF2400iS v2 Owner's Manual PDF

Pages 44
Year 2009
Language(s)
English en
1 of 44
1 of 44

Summary of Content for Yamaha EF2400iS v2 Owner's Manual PDF

Page 3

INTRODUCTION Congratulations on your purchase of your new Yamaha... This manual will provide you with a good basic understanding of the operation and main- tenance of this machine... If you have any questions regarding the operation or maintenance of your machine, please consult a Yamaha dealer...

Page 4

ments in product design and quality... Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your engine and this manual... If there is any question concerning this manual, please consult a Yamaha dealer...

Page 5

LIMITED WARRANTY (EF- AND EDL-SERIES)... 1

Page 6

THE PERIOD OF WARRANTY Any new EF-series or EDL-series Yamaha Generator purchased for private, non-commercial use from an authorized Yamaha consumer generator dealer in the conti- nental United States will be warranted against defects in material or work- manship for a period two (2) years from date of pur- chase, subject to exclusions noted herein... Any Yamaha non-commercial generator purchased and utilized for commercial or rental applications will be warranted for a period one (1) year from the date of purchase, subject to exclusions noted herein...

Page 7

The federal government requires each manufactur- er to maintain a complete, up-to-date list of all first purchasers against the possibility of a safety-relat- ed defect and recall... This list is compiled from the purchase registrations sent to Yamaha Motor Corporation, U... S... A... by the selling dealer at the time of your purchase... If you should move after you have purchased your new generator, please advise us of your new address by sending a postcard listing your Yamaha model name, engine number, dealer number (or dealers name) as it is shown on your warranty identification, your name and new mailing address... Mail to:

Page 8

Lisez le mode d'emploi et toutes les etiquettes avant de faire fonctionner la machine... Faites fonctionner uniquement dans des lieux bien aeres... Les gaz d'echappement contiennent du monoxyde de carbone... Verifiez si du carburant a ete renverse ou s'il fuit... Arretez le moteur avant de faire le plein de carburant... N'utilisez pas a proximite de materiaux inflammables... Il y a risque d'electrocution si le generateur fonctionne sous la pluie, dans la neige, ou pres de l'eau, gardez la machine ausec en toutes circonstances... Quand la gnratrice est en marche: Ne jamais entourer la gnratrice de cloisons ou d'crans... Ne jamais recouvrir la gnratrice d'une bote... Ne jamais disposer d'objets sur la gnratrice...

Page 9

YAMAHA MOTOR POWERED PRODUCTS CO... ,LTD... This engine meets **** California exhaust and evaporative emission regulations for small off-road engines... This engine conforms to Phase 2 U... S... EPA regulations for small nonroad engines... EMISSIONS COMPLIANCE PERIOD : CATEGORY A(EPA) EF: ********* DISPLACEMENT: *** cc EVAP F: ******** EMISSION CONTROL SYSTEM: EM This engine is certified to operate on unleaded gasoline... ENGINE OIL: SAE10W-30 TYPE: SE No other adjustments needed...

Page 10

any to get in your eye(s), see your doctor immedi- ately... If any fuel spills on your skin or clothing, immediately wash with soap and water and change your clothes...

Page 11

9 When covering the generator, be sure to do so only after the engine and muffler have completely cooled down...

Page 12

Before the generator can be connected to a build- ings electrical system, a licensed electrician must install an isolation (transfer) switch in the build- ings main fuse box... The switch is the connection point for generator power and allows selection of generator or main line power to the building... This will prevent the generator from charging the main power line (backfeeding) when the main power sup- ply has failed or has been turned off for line repair... Backfeeding can electrocute or injure line mainte- nance personnel... Also, generator and building electrical system damage can occur when normal operating power returns if unit is used without an isolation switch...

Page 13

CONTROL PANEL 1 Engine switch 2 Twin Tech (parallel running terminal) 3 DC protector 4 Oil warning light 5 AC pilot light 6 Overload indicator light 7 AC receptacle 8 DC receptacle 9 Ground (earth) terminal

Page 14

DC PROTECTOR The DC protector turns to OFF 2 automatically when electric device being connected to the generator is operating and current above the rated flows... To use this equipment again, turn on the DC protector by pressing its button to ON 1...

Page 15

TWIN TECH (TERMINAL FOR CONNECTING SPECIAL CABLES FOR PARALLEL RUNNING) This is the terminal for connecting special cables for par- allel running of two EF2400iS... The parallel running requires two EF2400iS and the special cables... (The rated output in parallel running is 3... 6 kVA and the rated current is 30... 0 A... ) The handling, operation procedure and the notes on usage are described in the PARALLEL RUNNING KIT OWNERS MANUAL included in the Parallel Running Kit... Consult a Yamaha dealer for this Parallel Running Kit...

Page 16

The engine and muffler will be very hot after the engine has been run... Avoid touching the engine and muffler while they are still hot with any part of your body or clothing during inspection or repair...

Page 17

9 Immediately wipe off spilled fuel with a clean, dry, soft cloth, since fuel may deteriorate paint- ed surfaces or plastic parts...

Page 18

9 Never operate the engine in a closed area or it may cause unconsciousness and death within a short time... Operate the engine in a well venti- lated area...

Page 19

TIP When starting the engine in areas where the ambient temperature is below 0C (32F), the engine automati- cally operates at the rated r/min (3,200 r/min) for 3 min- utes to warm up the engine

Page 20

9 When supplying precision equipment, electronic controllers, PCs, electronic computers, microcomputerbased equipment or battery chargers, keep the gen- erator a sufficient distance away to prevent electrical interference from the engine... Also ensure that electrical noise from the engine does not interfere with any other electrical devices located near the generator...

Page 21

9 Be sure all electric devices including the lines and plug connections are in good condition before connection to the generator...

Page 22

The overload indicator light (Red) 1 comes on when an overload of a connected electrical device is detect- ed, the inverter control unit overheats, or the AC output voltage rises... The electronic breaker will then activate, stopping power generation in order to protect the gen- erator and any connected electric devices... The AC pilot light (Green) will go off and the overload indicator light (Red) will stay on, but the engine will not stop running...

Page 23

9 The DC protector turns off 2 automatically if current above the rated flows during battery charging... To restart charging the battery, turn the DC pro- tector on by pressing its button to ON 1... If the DC protector turns off again, stop charging the battery immediately and consult a Yamaha dealer...

Page 24

Operating range of DC power supply (exclusively for charging 12-V battery) This power source is designed to charge batteries up to 40AH that are half-discharged... Do not charge batteries of a higher capacity than 40AH... The time required for recharging a battery varies depending on the discharge level of the battery... When the specific gravity of the battery reaches 1... 26 to 1... 28, charging is complete... When charging, check the battery's specific gravity once an hour... The average time for charging a half-discharged 40AH battery is approximately 5 hours... Be sure to check the battery fluid level before charging...

Page 25

Never smoke or make and break connections at the battery while charging... Sparks may ignite the bat- tery gas... Battery electrolyte is poisonous and dangerous, causing severe burns, etc... contains sulfuric (sul- phuric) acid... Avoid contact with skin, eyes or cloth- ing... Antidote: EXTERNAL-Flush with water... INTERNAL-Drink large quantities of water or milk... Follow with milk of magnesia, beaten egg or veg- etable oil... Call physician immediately... EYES: Flush with water for 15 minutes and get prompt medical attention... Batteries produce explo- sive gases... Keep sparks, flame, cigarettes, etc... , away... Ventilate when charging or using in closed space... Always cover eyes when working near bat- teries... KEEP OUT OF REACH OF CHILDREN...

Page 27

PERIODIC MAINTENANCE Safety is an obligation of the owner... Periodic inspection, adjustment and lubrication will keep your generator in the safest and most efficient condition possible... The most impor- tant points of generator inspection, adjustment, and lubrication are explained on the fol- lowing pages...

Page 28

*1 Initial replacement of the engine oil is after one month or 20 hours of operation... *2The air filter element needs to be cleaned more frequently when using in unusually wet or dusty areas... Since these items require special tools, data and technical skills, have a Yamaha dealer perform the service...

Page 29

TIP If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4- 1/2 turn past finger tight... However, the spark plug should be tightened to the specified torque as soon as possible...

Page 30

CARBURETOR ADJUSTMENT The carburetor is a vital part of the engine... Adjusting should be left to a Yamaha dealer with the professional knowledge, specialized data, and equipment to do so properly...

Page 31

The engine and muffler will be very hot after the engine has been run... Avoid touching the engine and muffler while they are still hot with any part of your body or clothing during inspection or repair...

Page 32

When cleaning, use the wire brush lightly to avoid damaging or scratching of the muffler screen and spark arrester...

Page 33

4... Oil the foam element and squeeze out excess oil... The foam element should be wet but not dripping...

Page 34

The engine should never run without the foam ele- ment; excessive piston and cylinder wear may result...

Page 35

2 Fuel in tank ... Fuel cock lever to ON... 2 Clogged fuel line ... Clean fuel line... 2 Clogged carburetor ... Clean carburetor...

Page 36

9 To prevent FIRE HAZARDS be sure to place the spark plug as far way as possible from the spark plug hole and carburetor area...

Page 37

2... Remove the fuel tank cap... Extract the fuel from the fuel tank into an approved gasoline container using a commercially available handsiphon... Then, install the fuel tank cap...

Page 38

7... Drain the fuel remaining in the carburetor into an approved container by loosening the drain screw 1 on the carburetor float chamber...

Page 39

1... Remove the spark plug, pour about one table- spoon of SAE 10W-30 or 20W-40 motor oil into the spark plug hole and reinstall the spark plug... Recoil start the engine by turning over several times (with ignition off) to coat the cylinder walls with oil...

Page 40

The above items and the corresponding acronyms are provided in accordance with U... S... EPA REGULATIONS FOR NEW NONROAD SPARK-IGNITION NONHANDHELD ENGINES and the CALIFORNIA REGULATIONS FOR 1995 AND LATER SMALL OFF- ROAD ENGINES... The acronyms conform to the latest version of the SAEs recommended practice docu- ment J1930, Diagnostic Acronyms, Terms, and Definitions For Electrical/Electronic System...

Page 41

Unit EF2400iS Type Forced air cooled 4-stroke gasoline OHV Cylinder Arrangement Inclined, 1 cylinder Displacement cm3 171 Bore Stroke mm (in) 66... 0 50... 0 (2... 60 1... 97) Operation Hours Hr 5... 08... 6 (rated load1/4 load) Fuel Unleaded gasoline Fuel Tank Capacity L (US gal, Imp gal) 6... 0 (1... 59, 1... 32) Engine Oil Quantity L (US qt, Imp qt) 0... 6 (0... 63, 0... 53) Ignition System TCI

Page 42

(parallel running terminal) 8 AC receptacle 9 Ground (earth) terminal 0 Overload indicator light q DC receptacle w DC protector (breaker) e Engine switch r Oil warning light t Speed limiter assembly y Oil level gauge u T... C... I... magneto i T... C... I... unit

Page 43

Read this manual carefully befor operating this machine... This manual should stay with this machine if it is sold...

Page 44

Read this manual carefully before operating this machine...

Manualsnet FAQs

If you want to find out how the EF2400iS Yamaha works, you can view and download the Yamaha EF2400iS v2 Owner's Manual on the Manualsnet website.

Yes, we have the Owner's Manual for Yamaha EF2400iS as well as other Yamaha manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Owner's Manual should include all the details that are needed to use a Yamaha EF2400iS. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Yamaha EF2400iS v2 Owner's Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Yamaha EF2400iS v2 Owner's Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Yamaha EF2400iS v2 Owner's Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Yamaha EF2400iS v2 Owner's Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Yamaha EF2400iS v2 Owner's Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.