Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference PDF

1 of 2
1 of 2

Summary of Content for Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference PDF

NOTE: All vehicle doors, hood, trunk or rear gate must be closed prior to activating the remote engine start system. Any open entry point will prevent starting or cause the system to shut down.

Upon successful activation, the remote start fob will ash and beep once**, the horn sounds once and the side marker lights, tail lights and parking lights ash once. The system will check certain safety preconditions before starting and if all conditions are met, the engine will start within ve (5) seconds. After the engine starts, the remote start fob will ash and beep twice**, the horn sounds once and the side marker lights, tail lights and parking lights ash once. While the engine is idling via the remote engine start system, the remote start fob will continue to ash once every three (3) seconds, the side marker lights, tail lights and parking lights will remain illuminated and the power window switches are disabled. The engine will continue to run for fteen (15) minutes if not operated. The system also has a timer that will allow the system to operate for a maximum of twenty (20) minutes (under multiple remote start activations). Using the ignition key to turn on the ignition resets the twenty (20) minute timer.

If the engine turns over but does not start (or starts and stalls) the remote engine start system will power off and then attempt the engine three (3) additional times. The system will not attempt to restart the engine if it determines a vehicle malfunction is preventing it from starting. If the engine does not start after the three (3) additional attempts, the remote engine start request will be aborted.

Remote Start Safety Parameters For safety and security reasons, the system will fail to start or shut down the engine during remote start operation if any of the following occur:

The remote start system has operated for twenty (20) minutes between ignition key cycles The horn will honk three (3) times and the parking lights will ash three (3) times The remote start system Service Mode is engaged The horn will honk ve (5) times and the parking lights will ash ve (5) times Any of the vehicles doors, trunk or rear gate are open / opened The horn will honk six (6) times and the parking lights will ash six (6) times The vehicles hood is open The horn will honk two (2) times and the parking lights will ash two (2) times The ignition key is resting in the ignition cylinder The horn will honk two (2) times and the parking lights will ash two (2) times The transmission shifter is not in the park position The horn will honk two (2) times and the parking lights will ash two (2) times The vehicles brake pedal is depressed before the vehicle ignition switch is turned on The horn will honk two (2) times and the parking lights will ash two (2) times The vehicles engine idle speed has reached a level over 3,500 RPM (this will cause the vehicle to shutdown) The vehicles security system is triggered by opening the door or rear gate (if the security system is armed at the

time of remote start activation)

In addition to the items above, if the vehicles engine management system determines there is a safety risk due to a vehicle related problem, the vehicle will shut down and the vehicles horn will honk three (3) times.

WARNING: TO AVOID DANGER OF CARBON MONOXIDE, NEVER REMOTE START A VEHICLE IN A CLOSED SPACE SUCH AS A CLOSED GARAGE.

NOTE: Laws in some communities require that the vehicle be within view of anyone using the Remote Engine Starter. In some area, use of the Remote Engine Starter may violate state, provincial or local laws. Before using the Remote Engine Starter, check your state, provincial and local laws.

* See your owners manual for more details. ** Provided that the remote start transmitter is within the operating range of the system.

REMOTE START QUICK REFERENCE*

Press and Hold For Two (2) Seconds

Remote Start Shutdown

Press Two (2) Times Within Three (3) Seconds

Remote Start Activation

Entering the Vehicle While it is Running via Remote Start 1. Unlock the vehicle doors using the remote keyless entry system. If the vehicles doors are unlocked manually

using the key, the vehicles security system will trigger (if the security system is armed prior to activating the remote start system) and the vehicles engine will turn off. Inserting the ignition key into the ignition cylinder and turning it to the on position or pressing the unlock button on the remote keyless entry transmitter will disarm the security system.

2. Enter the vehicle. 3. The engine will shut down upon opening any vehicle door, trunk, hatch or rear gate of 5-door / wagon vehicles. 4. Insert the key into the ignition and turn to the start position to re-start the engine.

Remote Start Con rming Transmitter Feature Your remote start transmitter is equipped with a unique bidirectional con rmation feature. This feature will allow the transmitters backlit button to display system status provided the vehicle and transmitter fall within the systems operating range. Typical transmitter button ash sequences are outlined below.

Transmitter Flash & Beep Sequence Feature Description

Flash when button is pressed (no audible beep) Indicates that the system is transmitting an RF signal

2 long ashes (no audible beep)following remote start activation (transmitter button is pressed 2 times within 3 seconds)

Indicates that the transmitter did not receive remote start activation con rmation from the vehicle system. The transmitter will automatically send one additional remote start activation attempt. This usually occurs when the operational range is at its limit or has been exceeded.

1 ash & 1 beep following remote start activation (transmitter button is pressed 2 times within 3 seconds)

Indicates that the transmitter has received remote start activation con rmation from the vehicle system.

2 ash & 2 beeps following remote start activation (transmitter button is pressed 2 times within 3 seconds)

Indicates that the transmitter has received con rmation of a successful start of the vehicle system (vehicle now running)

1 ash every 5 seconds (no audible beep) Indicates that the vehicle is running via remote start. If the transmitter is moved outside of the systems operating range, this sequence will time out after the normal 15 minute vehicle run cycle.

3 ashes & 3 beeps Indicates that the vehicles engine has turned off due to remote start system 15 minute time out, vehicle safety parameter or normal shut down.

Engaging or Disengaging Service Mode 1. Enter the vehicle and close all vehicle doors, trunk, hatch or rear gate of 5-door / wagon vehicles. 2. Verify that the transmission shifter is in the park position. 3. Turn the ignition key on. 4. Depress the vehicles brake pedal three (3) times (Press, Release, Press, Release, Press and continue to hold). 5. Press and release the remote start transmitter button three (3) times (pausing 1 second between presses).

The system will honk the vehicles horn each time the button is pressed. 6. The system will pause for 1 second then honk the vehicles horn three (3) times to indicate that service mode

has been engaged or honk one (1) time to indicate that the service mode has been disengaged. 7. Release the vehicles brake pedal and turn the ignition key off.

Important Note: When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.

Selectable Run-Time

The system is preprogrammed to run for fteen (15) minutes before automatically stopping. The programmed run period can be changed to alternate times using the following procedure.

1. Enter the vehicle and close all vehicle doors, trunk or rear gate. 2. Verify that the transmission shifter is in the park position. 3. Turn the ignition to the on then off, on then off, on then off, then

back on and leave on throughout the programming process. (on/off ignition cycles must be completed within 8 seconds). 4. The system will honk the horn the number of times corresponding to the

current run time setting. 5. Open and close the drivers door to advance to the next run time setting.

The system will honk the horn to the c

Manualsnet FAQs

If you want to find out how the Impreza Subaru works, you can view and download the Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference on the Manualsnet website.

Yes, we have the Remote Start Quick Reference for Subaru Impreza as well as other Subaru manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Remote Start Quick Reference should include all the details that are needed to use a Subaru Impreza. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference, simply download the document to your computer. Once downloaded, open the PDF file and print the Subaru Impreza 2.0i 5-Door 2014 Remote Start Quick Reference as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.