Sony FS-85USB Operating Instructions PDF

1 of 2
1 of 2

Summary of Content for Sony FS-85USB Operating Instructions PDF

3-248-453-12(1)

Foot Control Unit

Sony Corporation 2002 Printed in Japan

FS-85USB

Operating Instructions

For customers in the United States

INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and

receiver. Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV

technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

If you have any questions about this product, you may call: Sony Direct Response Center 1-(800)-222-7669 or write to: Sony Direct Response Center 12451 Gateway Blvd. Fort Myers, FL 33913

Declaration of Conformity Trade Name: SONY Model No.: FS-85USB Responsible Party:

Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell,

NJ 07649 USA Telephone No.: 201-930-6972 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This warranty is valid only in the United States. Diese Gewhrleistung gilt nur fr die USA.

English

Microsoft and Windows are trademarks of Microsoft Corporation, registered in the U.S.A. and other countries. Copyright 1995 Microsoft Corporation. All rights reserved. Portion Copyright 1995 Microsoft Corporation

Pentium is a registered trademark of Intel Corporation. All other trademarks and registered trademarks are trademarks or

registered trademarks of their respective holders. TM and R marks are omitted in this manual.

Deutsch

Microsoft und Windows sind in den USA und anderen Lndern Warenzeichen der Microsoft Corporation. Copyright 1995 Microsoft Corporation. Alle Rechte vorbehalten. Teil-Copyright 1995 Microsoft Corporation.

Pentium ist ein eingetragenes Warenzeichen der Intel Corporation. Alle anderen Warenzeichen und eingetragenen Warenzeichen sind

Warenzeichen oder eingetragene Warenzeichen der jeweiligen Eigentmer.

In dieser Anleitung sind die Warenzeichen nicht mit den Zeichen TM und R gekennzeichnet.

English

Before operating the unit, please read this manual thoroughly and retain it for future reference.

This Foot Control Unit is designed to be used with a personal computer equipped with a USB port. Install the supplied Digital Voice Editor on your computers hard disk.

Using the Foot Control Unit (See the illustration below)

1 Start the Digital Voice Editor. 2 Select [Options] from the [Tool] menu, click the

[Transcribing Key] tab, and check the settings of the [Enable Transcribing Keys] items. Make sure that they are as follows: [Playback]: F10

[Stop]: F11 [Skip Forward]: Ctrl + Right

[Skip Backward]: Ctrl + Left (Once you make the settings, you dont have to set them again.)

3 Connect the USB connector of the Foot Control Unit to the USB port of the personal computer.

Note on using Windows 98 When you connect the Foot Control Unit to the computer for the first time, the [Add New Hardware Wizard] message appears. In this case, follow the displayed instructions.

4 Push down on the right side of the pedal with your foot and keep it depressed to listen to recorded material.

Operation Foot position on the pedal

Listen Right side

Easy Search Left side (Skip backward)*

Easy Search Center top (Skip forward)*

Stop Release the pedal

* When you keep the pedal depressed, the operation functions as fast forward or backward.

Skipping forward or backward You can specify the length of time in seconds to skip forward or backward in the message using the Easy Search function. Select [Options] from the [Tool] menu, click the [Playback Options] tab, and select the number of seconds to skip forward or backward. Initial settings are as follows: [Skip Forward]: 10 seconds [Skip Backward]: 3 seconds

Troubleshooting The Foot Control Unit does not operate. Use a computer which supports the CPU specifications recommended in

System Requirements. Check to make sure the settings of the [Enable Transcribing Keys] items

as described in step 2 in Using the Foot Control Unit have been made. Do not disconnect the USB cable while the Digital Voice Editor is

starting up. If you do, restart the computer.

The message does not stop during an Easy Search even if you release the pedal. Open the Control Panel of Windows, select [Keyboard], click the [Speed]

tab, and select [Slow] for [Repeat rate].

You cannot use the shortcut keys of the application which you are using with the Digital Voice Editor. Change the settings for the shortcut keys on the display of the application

which you are using with the Digital Voice Editor.

There is no sound. Adjust the speaker volume on the application display, or adjust the

volume control of the computer.

Specifications Dimensions (w/h/d)

Approx. 192 51 121 mm ( (7 5 8 2 1

8 4 7

8 inches) not incl. cord

Mass Approx. 510 g (18 oz)

Supplied accessories Digital Voice Editor (CD-ROM) (1) Earphones (1)

Design and specifications are subject to change without notice.

Application to be installed Digital Voice Editor* * You cannot use Digital Voice Editor, ver. IX.

System Requirements Your computer and system software must meet the following minimum requirements. IBM PC/AT or compatible

CPU: 266MHz Pentium II processor or higher (450MHz Pentium III processor of higher recomended)

RAM: 64MB or more Hard disk space: 70MB or more CD-ROM drive USB port Sound board Display: High color (16 bit) or more and 800 x 480

pixels or more OS: Microsoft Windows XP Professional/Windows XP

Home Edition/Windows 2000 Professional/Windows Millennium Edition/Windows 98/98 Second Edition (standard installation)

Easy Search (Skip backward) Schnelles Suchen (Zurckschalten)

USB port of your computer USB-Anschluss am Computer

Deutsch

Lesen Sie diese Anleitung vor Inbetriebnahme des Gerts bitte genau durch und bewahren Sie sie zum spteren Nachschlagen sorgfltig auf.

Dieser Fuschalter ist fr PCs mit USB-Anschluss konzipiert. Die mitgelieferte Software Digital Voice Editor muss auf der Festplatte des Computers installiert werden.

Verwenden des Fuschalters (siehe Abbildung unten)

1 Starten Sie die Software Digital Voice Editor.

2 Whlen Sie [Options] im Men [Tool], klicken Sie auf die Registerkarte [Transcribing Key] und berprfen Sie die Einstellungen fr die Optionen unter [Enable Transcribing Keys]. Stellen Sie sicher, dass folgende Tastenbelegungen eingestellt sind: [Playback]: F10

[Stop]: F11 [Skip Forward]: Strg + Rechts

[Skip Backward]: Strg + Links Diese Einstellungen brauchen Sie nur einmal vorzunehmen.

3 Verbinden Sie den USB-Anschluss des Fuschalters mit dem USB-Anschluss am PC.

Hinweis zu Windows 98 Wenn Sie den Fuschalter zum ersten Mal an den Computer anschlieen, wird mglicherweise das Dialogfeld [Add New Hardware Wizard] angezeigt. Gehen Sie in diesem Fall nach den Anweisungen am Bildschirm vor.

4 Bettigen Sie die reche Seite des Pedals mit dem Fu, um eine Aufzeichnung wiederzugeben.

Funktion Fuposition auf dem Pedal Wiedergabe Rechte Seite

Schnelles Suchen Linke Seite (Zurckschalten)*

Schnelles Suchen Mitte oben (Weiterschalten)*

Stoppen Nehmen Sie den Fu vom Pedal.

* Wenn Sie das Pedal lnger bettigen, knnen Sie schnell zurck- bzw. weiterschalten.

Weiter-/Zurckschalten Sie knnen festlegen, um wie viele Sekunden beim schnellen Suchen in einer Aufzeichnung jeweils weiter- bzw. zurckgeschaltet wird. Whlen Sie [Options] im Men [Tool], klicken Sie auf die Registerkarte [Playback Options] und geben Sie die Anzahl an Sekunden fr das Weiter- bzw. Zurckschalten an. Im Folgenden sind die Anfangseinstellungen angegeben: [Skip Forward]: 10 Sekunden [Skip Backward]: 3 Sekunden

Strungsbehebung Der Fuschalter funktioniert nicht. Verwenden Sie einen Computer mit den unter Systemvoraussetzungen

genannten CPU-Spezifikationen. berprfen Sie, ob die Optionen unter [Enable Transcribing Keys] wie in

Schritt 2 unter Verwenden des Fuschalters beschrieben eingestellt sind.

Lsen Sie das USB-Kabel nicht, wenn die Software Digital Voice Editor startet. Andernfalls mssen Sie den Computer neu starten.

Wenn Sie beim schnellen Suchen das Pedal loslassen, stoppt die Aufzeichnung nicht. ffnen Sie in Windows die Systemsteuerung, whlen Sie [Keyboard],

klicken Sie auf die Registerkarte [Speed] und whlen Sie unter [Repeat rate] die Einstellung [Slow].

Die Tastenkombinationen der Anwendung, die Sie zusammen mit Digital Voice Editor verwenden, stehen nicht zur Verfgung. ndern Sie die Einstellungen fr die Tastenkombinationen in der

Anwendung, die zusammen mit Digital Voice Editor verwendet wird.

Es ist kein Ton zu hren. Stellen Sie die Lautstrke der Lautsprecher ber den

Anwendungsbildschirm oder mit dem Lautstrkeregler am Computer ein.

Technische Daten Abmessungen (B/H/T)

ca. 192 51 121 mm, ohne Kabel Gewicht

ca. 510 g Mitgeliefertes Zubehr

Digital Voice Editor (CD-ROM) (1) Ohrhrer (1)

nderungen, die dem technischen Fortschritt dienen, bleiben vorbehalten.

Zu installierende Anwendung Digital Voice Editor* * Digital Voice Editor, Version IX, kann nicht verwendet werden.

Systemvoraussetzungen Ihr Computer und die Systemsoftware mssen den folgenden Mindestvoraussetzungen entsprechen, damit Sie mit dem Produkt arbeiten knnen: IBM PC/AT oder Kompatibler

CPU: Pentium II-Prozessor mit 266 MHz oder hher (Pentium III-Prozessor mit 450 MHz oder hher empfohlen)

RAM: mindestens 64 MB Festplattenplatz: mindestens 70 MB CD-ROM-Laufwerk USB-Anschluss Sound-Karte Bildschirm: mindestens High Color (16 Bit) und

mindestens 800 x 480 Pixel Betriebssystem: Microsoft Windows XP Professional/

Manualsnet FAQs

If you want to find out how the FS-85USB Sony works, you can view and download the Sony FS-85USB Operating Instructions on the Manualsnet website.

Yes, we have the Operating Instructions for Sony FS-85USB as well as other Sony manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Operating Instructions should include all the details that are needed to use a Sony FS-85USB. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Sony FS-85USB Operating Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Sony FS-85USB Operating Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Sony FS-85USB Operating Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Sony FS-85USB Operating Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the Sony FS-85USB Operating Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.