Sencor SHI 4500GD Iron User Manual PDF

1 of 6
1 of 6

Summary of Content for Sencor SHI 4500GD Iron User Manual PDF

06/2019- 1 -Copyright 2019, Fast R, a.s.

EN Hair straightening iron Translation of the original manual

SHI 4500GD

06/2019- 2 -Copyright 2019, Fast R, a.s.

EN Hair straightening iron Important safety instructions

READ CAREFULLY AND STORE FOR FUTURE USE. General warnings This appliance may be used by children 8  years of age and older and by persons with physical or mental impairments or by inexperienced persons, if they are properly supervised or have been informed about how to use the product in a safe manner and understand the potential dangers.

Children must not play with the appliance. Cleaning and maintenance performed by the user must not be performed by unsupervised children.

In the event that the power cord is damaged, have it repaired at a  professional service centre to prevent causing a dangerous situation. It is forbidden to use the appliance if it has a damaged power cord.

Warning: Do not use this appliance in the vicinity of water.

Warning: Do not use this appliance near baths, showers, washbasins or other containers containing water.

06/2019- 3 -Copyright 2019, Fast R, a.s.

When using the appliance in the bathroom, unplug it from the socket after use by removing the plug from the socket, as the vicinity of water poses a danger, even when the appliance is turned off.

To ensure additional safety, it is recommended to install an Residual Current Device (RCD) into the electric circuit to the bathroom with a  maximum current rating of 30 mA. Ask an electrician for advice.

Electrical safety Before connecting this appliance to a power socket, make sure that the voltage stated on its rating label corresponds to the voltage in your power socket. Connect the appliance only to a properly grounded socket. Do not use an extension cord. Do not disconnect the appliance from the power socket by pulling on the power cord. This could damage the power cord or the power socket. Disconnect the power cord from

the power socket by pulling on the plug. Do not place the power cord of the appliance over sharp objects. Make sure that the power cord does not hang over the edge of a table and that it is not touching a heated or

hot surface. Do not place the power cord in the vicinity of hot surfaces. Keep the power cord dry. Never use the appliance if you have wet hands or feet. Do not connect and disconnect the power cord to and from the power socket with wet hands. Do not uncover the electrical parts of the appliance. They do not contain any components repairable by the user. Have the appliance serviced by qualified persons. To avoid potential injury by electrical shock, do not spray the appliance or its power cord with water and do not submerge it in water or any other liquid. Do not use the appliance if it is not working correctly, if it has been damaged or has been submerged in water. Always turn off the appliance and disconnect it from the power socket when you have finished using it. To avoid the danger of injury by electrical shock, do not repair the appliance yourself or make any adjustments to it. Have all repairs or adjustments performed at an authorised

service centre. Tampering with the appliance during the warranty period may void the warranty.

Safety during use This appliance is designed for use in households, offices and similar types of areas. Do not use it in industrial surroundings or outdoors or in rooms with high humidity, i.e.

laundries or bathrooms. Do not use the appliance for any other purposes than those for which it was designed. Only use the appliance with the original accessories from the manufacturer. Never use accessories, which have not been supplied with this appliance or which have not been

explicitly recommended by the manufacturer. Do not expose the appliance to direct sunlight and do not place it near an open fire or appliances that are a source of heat, e.g. electric or gas stoves. Only store and use the

appliance away from flammable or volatile substances. Only position the appliance on a clean, dry, horizontal and stable surface. Do not position the appliance on the edge of a kitchen countertop or table, or use it on the drainboard

of a kitchen sink. Likewise, do not place it on window sills. Do not place any items on to the appliance and do not step or sit on it. Do not use the appliance in an excessively dusty environment. The appliance must not be used for styling wigs, hairpieces or synthetic hair. Never leave the appliance switched on without supervision. Protect the appliance against being dropped on the floor or table, even from low heights and against items falling on it. When the appliance is running, watch out for children and household pets. If the appliance is operating or has not fully cooled down, do not place it on soft underlays (e.g. carpets, bed linen, towels, etc.) and never cover it. When the appliance is used in the vicinity of children, pay increased attention and always place the appliance out of their reach. Do not place any paper or plastic items between the arms of the appliance. Prevent the appliance from coming into contact with skin. Never use the iron on synthetic hair or animal fur. Do not carry the appliance when it is hot. Always turn off the appliance and disconnect it from the power socket when not using it, when not planning on using it and when leaving it without supervision, before cleaning

or moving it. Thoroughly clean dust, fats and hairdressing agents (e.g. gels, mousse, sprays, etc.) from the plates after each use these lower the performance and lifetime of the plates. Never wash the appliance under running water or submerge it in water or another liquid. No part of this appliance is designed to be washed in a dishwasher. Before storing always allow the appliance to fully cool down.

06/2019- 4 -Copyright 2019, Fast R, a.s.

SHI 4500GD

2

3 4

1

5 7

6

8

A

- 5 - 06/2019Copyright 2019, Fast R, a.s.

EN Hair straightening iron User's manual

Prior to using this appliance, please read the user's manual thoroughly, even in cases, when one has already familiarised themselves with previous use of similar types of appliances. Only use the appliance in the manner described in this users manual. Keep this user's manual in a safe place where it can be easily retrieved for future use. In the event that you hand this appliance over to somebody else, make sure to also include this user's manual.

We recommend saving the original cardboard box, packaging material, purchase receipt and responsibility statement of the vendor or warranty card for at least the duration of the legal liability for unsatisfactory performance or quality. In the event of transportation, we recommend that you pack the appliance in the original box from the manufacturer.

Carefully unpack the appliance and take care not to throw away any part of the packaging before you find all the parts of the appliance.

DESCRIPTION OF THE APPLIANCE AND ACCESSORIES A1 Display A2 Hanging loop A3 Swivel power cord end A4 Main switch A5 Increase temperature button

A6 Decrease temperature button A7 Ironing plates with infra-red heat

indicators A8 Ionisation function indicator

PURPOSE OF USE AND FEATURES OF THE HAIR STRAIGHTENING IRON The hair straightening iron is intended exclusively for straightening and styling

human hair. It must never be used for styling wigs, hairpieces, synthetic hair or for straightening animal fur.

The iron is equipped with an automatic safety shut-off function, that turns it off after 60 minutes of inactivity.

The surface of the ironing plates is coated with titanium and enables operating temperatures from 100  C  to 230  C. The temperature can be controlled in 10 C increments.

APPLICATION

TURNING ON AND SETTING THE TEMPERATURE Connect the iron to a power socket. The display A1 will show OFF. Hold down button A4 for longer than 3 seconds. The appliance will beep and the

default temperature of 180 C will be lit on the display and the iron will start heating up. The blue ionisation function indicator A8 and the infra-red plate heat indicators A7 are lit.

The temperature can be adjusted in 10-degree increments in the range from 100 C to 230 C using buttons A5 and A6.

Note: If "888" appears on the display, this indicates that there is a malfunction of the heat sensor or iron. If this happens, disconnect the iron from the power grid and contact a service centre.

TEMPERATURE LOCK FUNCTION This function prevents accidental changes to the temperature while the iron is being

used. Activate the function by holding down button A5 for longer than 3 seconds. The text LOC will appear on the display and the set temperature will be locked, i.e. no button will react when pressed.

Deactivate the function by holding down button A5 for longer than 3 seconds. The text LOC will disappear.

AUTOMATIC SHUT-OFF FUNCTION If no action is taken after turning on the iron, i.e. no button is pressed, then for safety

reasons, the iron will turn off automatically after 60 minutes of inactivity. It will start again after button A4 is pressed.

Attention: The automatic shut-off is intended only for cases, where you forget to turn off the iron using button A4. Do not use the automatic shut-off to intentionally turn off the iron.

TEMPERATURE DEPENDING ON HAIR TYPE The suitable temperature for straightening hair depends on the hair structure.

Depending on the type of hair, an incorrectly selected temperature may cause the hair to dry out, become brittle or in the worst case to burn. Therefore, first try ironing at a low temperature (100 C) and set a higher temperature only when necessary.

The information contained in the following table is for reference purposes only. It may differ depending on hair type.

Hair type Temperature Fine, damaged, discoloured, highlighted or dyed hair 100 C to 150 C Normal, lightly wavy hair 150 C to 190 C Very heavy, curly, unyielding hair 190 C to 230 C

PROCEDURE FOR IRONING HAIR Wash your hair thoroughly, dry it completely and brush through thoroughly so that

it is smooth and without knots. Separate this prepared hair using clips into equally wide strands (about 5 cm wide). Start to iron the back part of the head at the lower strands of hair at the root place

the strand of hair between the plates and gently press the handle of the iron. With a sliding motion pull the iron all the way to the ends of the hair.

Repeat the procedure for the same strand of hair until you achieve the desired appearance.

Continue in the same way with the remaining strands of hair (first on the front part of the head and ending at the sides).

Before the final combing, allow the hair to fully cool down.

Attention: Do not touch the ironing plates - there is a danger of burns! Do not leave the iron in the one spot for longer than 5 seconds as hair could be burnt. Use the iron only on healthy hair. Do not use the iron on oily, stuck together or sweaty hair. On perm or coloured hair only use the iron infrequently.

Tip: Adjust the speed of movement of the iron on the hair strands according to their character (fine hair is more sensitive to a  hot surface and requires a significantly shorter ironing time than stronger hair).

TURNING OFF THE IRON When you have finished ironing, turn off the iron by holding down button A4.

A beep will be made and the display will show OFF. Disconnect the iron from the power socket.

Attention: Allow the iron to fully cool down before storing!

CLEANING AND MAINTENANCE Attention: Clean the ironing plates only after they have fully cooled down! No part of the iron may be submerged in water or washed under running water!

To clean the outside parts of the iron and the ironing plates, use a  fine cloth dipped in lukewarm water. Do not use aggressive cleaning agents, paint thinners or solvents. Using these solutions could damage the surface of the product. The surface of the iron plates does not need any further cleaning.

STORAGE When not using the iron for an extended period of time, do the following: Clean the iron as described in chapter Cleaning and maintenance. Place the iron in a safe, dust-free, clean and dry place that is out of reach of children.

TECHNICAL SPECIFICATIONS Rated voltage range .................................................................................................... 100240 V AC Rated frequency........................................................................................................................50/60 Hz Rated power ................................................................................................................................ 55-60 W Temperature range .........................................................................................................100 to 230 C Electrical shock protection class ........................................................................................................ II

EXPLANATION OF TECHNICAL TERMINOLOGY

Safety class for electrical shock protection: Class II Electrical shock protection is provided by double or heavy-duty insulation.

We reserve the right to change text and technical specifications.

- 6 - 06/2019Copyright 2019, Fast R, a.s.

INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS Dispose of used packaging material at a site designated for waste in your municipality.

DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT This symbol on products or original documents means that used electric or electronic products must not be added to ordinary municipal waste. For proper disposal, renewal and recycling hand over these appliances to determined collection points. Alternatively, in some European Union states or other European countries you may return your appliances to the local retailer when buying an equivalent new appliance. Correct disposal of this product helps save valuable natural resources

and prevents potential negative effects on the environment and human health, which could result from improper waste disposal. Ask your local authorities or collection facility for more details. In accordance with national regulations penalties may be imposed for the incorrect disposal of this type of waste. For business entities in European Union states If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the necessary information. Disposal in other countries outside the European Union.

Manualsnet FAQs

If you want to find out how the SHI 4500GD Sencor works, you can view and download the Sencor SHI 4500GD Iron User Manual on the Manualsnet website.

Yes, we have the User Manual for Sencor SHI 4500GD as well as other Sencor manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The User Manual should include all the details that are needed to use a Sencor SHI 4500GD. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Sencor SHI 4500GD Iron User Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Sencor SHI 4500GD Iron User Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Sencor SHI 4500GD Iron User Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Sencor SHI 4500GD Iron User Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Sencor SHI 4500GD Iron User Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.