Sealey LED100WS Worklight Instruction Manual PDF

1 of 2
1 of 2

Summary of Content for Sealey LED100WS Worklight Instruction Manual PDF

20W COB LED R/ChaRgE WiRELEss spEakER WORk Light+pOWER Bank Model no: LED100Ws

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. safEty 9 Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or

damaged DO nOt use. 9 ensure the lamp is fully charged before initial use. 8 DO nOt charge in damp conditions. 8 DO nOt turn the lamp on when it is being charged. 8 DO nOt shine directly into your, another persons or an animals eyes. 8 DO nOt allow children to use the lamp. 8 DO nOt handle or move the lamp whilst it is being charged. 8 DO nOt use the lamp if you suspect that the battery or the lamp casing is damaged. 8 DO nOt leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently

recharge the battery at least once every six months of non-use. 8 DO nOt attempt to open, disassemble, modify or service the battery pack. 8 DO nOt crush, puncture, short external contacts or dispose of in fire or water. 8 DO nOt expose to temperatures above 60C (140). 9 Replace only with the battery pack designated for this product. 9 Recycle or dispose of used battery as stipulated by local regulation. 9 If the electrolyte in the cells gets on your skin or eyes, rinse thoroughly with water. 8 DO nOt connect your small devices to charge while the power bank is in the process of charging. 8 DO nOt immerse in water. 8 DO nOt place near a fire or any other source of intense heat battery could explode if heated. 9 Battery must be recycled or disposed of according to local regulations.

2. intRODuCtiOn 3-in-1 Function work light made of a strong nylon plastic with thermoplastic rubber edges for durability. Features an ultra bright 20W CoB led light producing up to 1100 lumens with three light settings: High 1100lm, Mid 580lm, low 350lm (working time: 3, 5 and 15 hours respectively). Work light also includes two good quality wireless speakers which can be easily linked to your tablet or smartphone. Fixed to the rear is a sturdy 180 adjustable stand which can also be used as a carry handle. Has four strong magnets on the back for easy mounting to metal applications such as a tool chest. Built-in power bank with a USB output and led charge indicator. Micro USB charging lead included.

3. spECifiCatiOn Model no: ............................................................led100WS Battery: ........................................................3.7V 8Ah li-poly Charging Time: .............................................................8-10hr led Qty: ........................................................ 20W CoB led lumen output: ............................................................1100lm nett Weight: ................................................................... 790g Running Time: ..............................................................3-15hr Speaker output: ............................................................. 85db USB output: ............................................................... 5V / 1A

SpeakerLight fig.1

led100WS Issue 1 20/02/19Original Language Version Jack Sealey limited

Refer to instructions

4. OpERatiOn nOtE: Charge before first use, see section 4.5. 4.1. tO tuRn On thE Light: (fig.2) 4.1.1. Short press the main power button

to turn the light On/Off. 4.1.2. There are 3 lighting modes: high, mid

and low. Keep pressing the button until you reach the desired setting.

4.2. tO COnnECt a WiRELEss EnaBLED DEviCE (fig.2)

4.2.1. Press and hold the wireless activation button for a couple of seconds until wireless-on tone is heard.

4.2.2. You can connect and play music from your mobile phone, tablet or other portable audio device. Keep the button pressed to turn off.

4.3. tO aDjust vOLuME: (fig.2) 4.3.1. Press and hold plus (+) button to increase volume. Press and hold minus (-) button to reduce volume. 4.4. tO MOvE fORWaRD OR BaCkWaRD in yOuR pLayList: (fig.2) 4.4.1. Short press plus (+) button to move to the next song. Short press minus (-) button to go to the previous song. 4.5. tO ChaRgE thE Light: (fig.3) 4.5.1. open the transparent cover on the back of the

device. Plug a micro USB cable into the 5V input and connect it to a power adaptor, home computer, laptop, etc. The indicator light will be on to show the power capacity. 3 blue leds are on when it is fully charged.

4.6. tO ChaRgE yOuR sMaLL DEviCEs: (fig.3) 4.6.1. Plug a USB cable into the 5V output at the base

of the light and connect it to your mobile phone, camera, etc.

WaRning! DO nOt connect your small devices to charge while the power bank is being charged.

Light On/Off

Wireless Activation

(Hold)Volume up (Press) Forward Skip (+)

(Press) Backwards Skip (-) (Hold) Volume Down

fig.2

5V Charger Input Indicator lights

USB Output Socket

fig.3

sealey group, kempson Way, suffolk Business park, Bury st Edmunds, suffolk. ip32 7aR 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

EnviROnMEnt pROtECtiOn Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REguLatiOns dispose of this product at the end of its working life in compliance with the eU directive on Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

note: It is our policy to continually improve products and as such we reserve the

Manualsnet FAQs

If you want to find out how the LED100WS Sealey works, you can view and download the Sealey LED100WS Worklight Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Sealey LED100WS as well as other Sealey manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Sealey LED100WS. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Sealey LED100WS Worklight Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Sealey LED100WS Worklight Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Sealey LED100WS Worklight Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Sealey LED100WS Worklight Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Sealey LED100WS Worklight Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.