Sealey UWRC01 Remote Control Instruction Manual PDF

1 of 1
1 of 1

Summary of Content for Sealey UWRC01 Remote Control Instruction Manual PDF

INSTRUCTIONS FOR: UNIVERSAL WINCH REMOTE CONTROL MODEL NO: UWRC01

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance.

2. SAFETY INSTRUCTIONS

1. INTRODUCTION & SPECIFICATION

3.1. Fit the battery by sliding off the cover, fit the battery taking care to observe the polarity indicated on the circuit board and relace cover. 3.2. Remove the waterproof cover from the four pin socket on the end of the winch and fit the receiver unit. Take note of the orientation of the key way on the receiver unit. Tighten the securing ring. 3.3. Turn on the switch on the side of the hand held control unit.

3. OPERATION

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.

DO NOT enter the danger zone (the area of the winch drum, the fairlead (if fitted), the pulley block (if used) the hook and the motor). DO NOT approach or span the wire rope whilst the winch or puller is under load. DO NOT operate a winch or puller when under the influence of alcohol, drugs or medication. WARNING! Turn off the power switch on the side of the hand held control unit, before working in or around the fairlead or wire rope drum (the danger zone). WARNING! Never tuck the hand held control unit under the arm, or allow anyone else to hold it, so as to avoid it being accidentally activated. Wear eye protection, insulated work clothes, non-slip shoes, keep hair tied up and wear thick leather gloves. Remove all jewellery. Inspect winch or puller, wire rope, hooks and other accessories frequently. A mashed, pinched, kinked or frayed wire rope with broken strands should be replaced at once, because a damaged rope has reduced load carrying capability. NOTE: The safety precautions and instructions discussed in this manual can't cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product and must be applied by the operator.

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. IMPORTANT: No liability is accepted for incorrect use of this product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.

01284 757500

01284 703534 sales@sealey.co.uk

Sole UK Distributor, Sealey Group, Kempson Way, Suffolk Business Park, Bury St. Edmunds, Suffolk, IP32 7AR

www.sealey.co.uk W e b

email

Original Language Version UWRC01 Issue: 1 - 12/12/13

Universal wireless remote control kit has a 4 pin plug-and-play receiver and is compatable with Sealey ATV, Self Recovery and Recovery winches. With a range of up to 30mtr (dependant on environment), a wireless remote control is a must have accessory for any electric winch. Both the receiver and handset are weatherproof making them ideal for off roaders and recovery trucks, enabling the operator to stand well clear or sit in the cab with no restrictions. Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UWRC01 Contents: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 x handheld control unit, 1 x 4-pin plug-and-play receiver unit Range: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30mtr Battery Type: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MN21 23A (supplied)

Jack Sealey Limited

Battery Removal Slide the battery cover off and remove the battery, dispose of it in

accordance with local authority guidelines. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containingbatteries(asdefinedwithintheseregulations),that they are registered with Valpaks registered compliance scheme. Jack Sealey Ltds Batteries Producer Registration Number

(BPRN) is BPRN00705.

Environmental Protection. Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.

WEEE Regulations. Dispose of this product a

Manualsnet FAQs

If you want to find out how the UWRC01 Sealey works, you can view and download the Sealey UWRC01 Remote Control Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Sealey UWRC01 as well as other Sealey manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Sealey UWRC01. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Sealey UWRC01 Remote Control Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Sealey UWRC01 Remote Control Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Sealey UWRC01 Remote Control Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Sealey UWRC01 Remote Control Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Sealey UWRC01 Remote Control Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.