LEVELLING RAMPS - THREE STAGE 2.5T PER RAMP 5T PER PAIR MODEL NO: WL301
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY WARNING! The levelling ramp is not to be used to raise a vehicle for maintenance or service purposes. 8 DO NOT under any circumstances go underneath the caravan/campervan whilst the levelling ramp is in use. WARNING! For safe use of the levelling ramp, the tyre is to be fully resting within the perimeter of the ramp with no edge overhang. 8 DO NOT put another raised item under the leveller to increase the overall height, other than a flat timber sheet that you may wish to use
on a soft surface. IMPORTANT: No modifications should be made to this product.
8 DO NOT use on excessively soft terrain, may cause bending or cracking. 8 It is strongly recommended that ramps are to be used on a hard level surface, preferably concrete. 9 It is advisable to have a second person directing the driver onto the levelling ramps and for positioning the ramps and chocks. 9 Always drive slowly onto the ramp. 9 Always apply the handbrake. 9 Only one leveller is to be used per wheel.
NOTE: If the ground is soft it may be beneficial to place a flat timber sheet under the leveller to minimise sinkage.
2. INTRODUCTION Ideal for campervans and caravans (capacity 5tonne per pair). Not to be used as a lifting ramp for the purpose of working underneath the vehicle. Suitable for single axle vehicles only. Raise wheels to various heights using different points on each ramp, to level vehicle out. Anti roll off step at end of ramp. Durable and easy to clean UV resistant high-density polyethylene with a non-slip surface. Designed to interlock with Model No. WLC01 to securely chock vehicle in place once it is level.
3. SPECIFICATION Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .WL301 Capacity Pair: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5tonne Extended Dimensions (LxWxH): . . . . . 560x200x100mm (Platform + 30mm End Ridge) Nett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.6kg
4. OPERATION 4.1. Position the leveller in front of the wheel/wheels you wish to level. 4.2. Pull the caravan or drive the campervan in a forward motion onto the levelling ramp to the desired height. 4.3. The leveller has three height positions. 40/70/100mm. 4.4. Apply brakes, it is advisable to use chocks to hold vehicle in place and to help reduce roll back. (Model No. WLC01 - Sold seperately). 4.5. Check that the tyre is fully supported by the levelling ramp and chock. 4.6. The use of a spirit level is recommended to assist with levelling the caravan. (Not included). NOTE: If the ground is soft it may be beneficial to place a flat timber sheet under the leveller to minimise sinkage.
5. MAINTENANCE 5.1. Wipe clean after use. 5.2. Check before and after use for wear or damage.
WL301 | Issue 1 10/01/2019Original Language Version Jack Sealey Limited
Refer to instructions