Sealey MAC06 Inflator Instruction Manual PDF

1 of 2
1 of 2

Summary of Content for Sealey MAC06 Inflator Instruction Manual PDF

tyre inflator/Mini air CoMPreSSorS 12V heaVy duty model noS: MaC04, MaC05, MaC06, MaC07

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. Safety WarninG! Read instructions before use. Suitable for 12V operation only. WarninG! This compressor is capable of producing a high pressure. do not inflate any item beyond its maximum capacity. 8 do not leave the unit unattended while in operation. 9 Check capacity and maximum pressure of inflatable before commencing inflation. 9 monitor the pressure gauge while in operation. 9 The gauge should be used as an indication of pressure only. We recommend the use of a dial pressure gauge for definitive reading. 9 locate compressor on an appropriate surface for use. 9 The 12V auxiliary plug (MAC04) must not be substituted with any other type of plug or electrical supply. 8 do not direct inflation hose connector head at yourself, others or animals. 8 do not carry by the hose, or pull the hose sharply from a valve. 8 do not pull the power cable from the vehicle accessory socket or battery terminal by the power lead. 8 do not get the compressor wet or use in the rain. 8 do not use the compressor for a task it was not designed to perform. 8 do not operate the compressor when you are tired, under the influence of alcohol, drugs or intoxicating medication. 8 do not operate the compressor if any parts are missing as this may cause failure or possible personal injury. 8 do not open the unit. 9 Keep children and non essential persons away from the inflation area. 9 Keep the compressor clean and in good condition. 9 Replace or repair damaged parts. Use recommended parts only. non authorised parts may be dangerous and will invalidate the

warranty.

2. introduCtion A range of heavy-duty mini air compressors with delivery between 25ltr and 95ltr/min. Air output hose features quick release coupling. Suitable for inflating tyres on lawnmowers, motorcycles, cars, vans and 4x4s and commercial vehicles. Supplied in a storage bag with high pressure hose with screw-on connector and accessory kit including ball needle and adaptors for inflatables.

3. SPeCifiCatione

Model no MaC04 MaC05 MaC06 MaC07 Hose length 1500mm 4500mm 7500mm 7500mm

Power cord length 3mtr 3mtr 3mtr 3mtr

operating voltage 12V 12V 12V 12V

Tyre Inflation time (175/70/R13 tyre)

0-30psi in 139sec 0-30psi in 104sec 0-30psi in 60sec 0-30psi in 45sec

maximum current 13A 20A 33A 40A

Air delivery 25ltr/min 50ltr/min 75ltr/min 95ltr/min

Power connection Accessory plug Battery clamps Battery clamps Battery clamps

Applications cars lawnmowers, motorcycles, cars, vans

cars, vans, 4x4s cars, vans,4x4s commercial vehicles

maximum pressure 100psi 150psi 150psi 150psi

Weight 1.85kg 2.91kg 4.65kg 6.58kg

4. oPeration

WarninG! Ensure you have read and understood the safety instructions. Place the compressor on a sound, flat surface ensuring that the inflation air hose can reach the tyre valve.

4.1. Remove the valve cap and screw the air hose onto the tyre valve. iMPortant: Inflation will only be effective if the connector head is fully fitted and secured onto the valve.

mAC04, MAC05, MAC06, MAC07 Issue:2 (H) - 08/03/19Original Language Version Jack Sealey limited

Refer to instruction

manual

4.2. check the pressure gauge to determine the amount of pressure already in the tyre. The gauge can be used without switching the unit on. We recommend however the use of a dial pressure gauge for a definitive reading.

check that the compressor on/off switch is in the off position before connecting to the power supply. MaC04: Insert the plug into the vehicles accessory socket. iMPortant: make sure that the maximum current draw is within the capacity of the accessory socket. MaC05, MaC06, MaC07: Connect the terminal clips to the battery, ensuring the correct polarity. Start the vehicle engine and switch the compressor on. View the pressure gauge to determine when the correct pressure has been achieved. Switch the compressor off to stop the supply of air. note: As the delivery pressure increases, the pump delivery volume will decrease. 4.3. Unscrew the air hose from the tyre valve. Switch off the vehicle engine. Replace the dust cap onto the valve. 4.4. After use, disconnect the compressor from the vehicle accessory socket or battery and store it in a safe, dry location. 4.5. General inforMation 4.5.1. The time it will take to inflate a tyre will depend upon the amount of air required. 4.5.2. Should the compressor fail to start when switched on, check the connections and fuse (see section 5.1.) note: The compressor may also be used to inflate items such as inflatable dinghies, sports balls, air beds etc. Use the appropriate inflation nozzle for the item. Caution: Some items may not indicate pressure required or the maximum pressure. Be careful not to over-inflate. note: The pressure gauge is not a calibrated instrument. It is recommended to use an approved dial pressure gauge for a definitive reading. 4.6. The MAC05, MAC06, MAC07 are fitted with a thermal cut-out which will operate after about 30 minutes. If this happens, switch the

compressor off and allow to cool for about 10 minutes.

5. MaintenanCe 5.1. fuSeS All the compressors are protected by an automotive style blade fuse. The fuse on the MAC04 is situated in the connector plug, whereas the larger three models have their fuses housed in the rubber holder which is part of the supply lead. do not replace the fuse with any not of the same specification as the original. 5.2. filter An inlet filter is fitted which may be cleaned with mild soapy water. To remove the filter, unscrew the filter housing (fig.1). When washed, allow the filter to dry and then replace.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St edmunds, Suffolk. iP32 7ar 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

enVironMent ProteCtion Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

Weee reGulationS Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. important: no liability is accepted for incorrect use of this produc

Manualsnet FAQs

If you want to find out how the MAC06 Sealey works, you can view and download the Sealey MAC06 Inflator Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Sealey MAC06 as well as other Sealey manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Sealey MAC06. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Sealey MAC06 Inflator Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Sealey MAC06 Inflator Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Sealey MAC06 Inflator Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Sealey MAC06 Inflator Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Sealey MAC06 Inflator Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.