INSTRUCTIONS FOR
12-24V ANTI-THEFT BATTERY TERMINAL AND FUSE HOLDER MODEL NO: BTANT1224V
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY 1.1. PERSONAL PRECAUTIONS
Ensure that there is another person within hearing range and close enough to come to your aid, should a problem arise when working near a lead-acid battery.
Wear safety eye protection and protective clothing. Avoid touching eyes while working near battery. Have fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. Washimmediatelywithsoapandwaterifbatteryacidcontactsskinorclothing.Ifacidenterseye,flusheyeimmediatelywithcool,
clean running water for at least 15 minutes and seek immediate medical attention. Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
current which is high enough to weld such items to the vehicle and cause severe burns. Ensure that hands, clothing (especially belts) are clear of fan blades and other moving or hot parts of engine. Remove ties and
contain long hair. DO NOTsmokeorallowasparkorflameinthevicinityofthebatteryorengine.
1.2. GENERAL SAFETY INSTRUCTIONS Familiarise yourself with the application, limitations and potential hazards of the product. Also refer to the vehicle manufacturers
hand book. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN. Keep tools and other items away from the engine and ensure that you can see the battery and working parts of engine clearly. Ifthebatteryterminalsarecorrodedordirty,cleanthembeforefittingtheproduct. Keep children and unauthorised persons away from the work area. R WARNING! To prevent the risk of sparking, short circuit and possible explosion DO NOT drop metal tools in the battery area, or allow
them to touch the battery terminals. Ensure there is effective ventilation to prevent a build-up of explosive gases.
2. INTRODUCTION Battery isolator switch. Fused bypass that maintains computer settings, radio and clock, while the battery is disconnected. Fits both 12V & 24V batteries.
3. SPECIFICATION Model No: ........................................................ BTANT1224V Continuous rate: ............................................................ 125A Crank rate: .....................................................................500A Voltage: .................................................................... 12V-24V Cable size: ................................................................4-6AWG
4. INSTALLATION Refer to fig.1 4.1. Disconnect negative then positive battery lead. 4.2. Fit one end of the fused bypass link to the Anti-theft terminal clamp bolt. Fit the other end to the vehicles original clamp bolt. 4.3. Unscrew green knob anticlockwise and remove. 4.4. Connect the vehicles Positive battery lead and tighten clamp. 4.5. Fit the vehicles Negative battery lead with the Anti-theft terminal and tighten clamp. Screw green knob clockwise back into Anti-theft
terminal. 4.6. The fused link will maintain computer settings, radio, clock etc. whilst the battery is disconnected.
Refer to instruction
manual
BTANT1224V | Issue 1 21/05/15Original Language Version Jack Sealey Limited
Wear eye Protection
Warning: Explosive Material
Warning: Corrosive substance