WORKSAFE HALF MASK RESPIRATORS AND FILTER CARTRIDGES MODEL NOS: 9360, 9360/61, 9360/62, 9360/63, 9360/66
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when
using this product. IMPORTANT! NOT FOR USE WITH TOXIC PAINTS SUCH AS ISOCYANATE. WARNING! DO NOT use in an oxygen deficient atmosphere (below 19% by volume). WARNING! DO NOT use in an oxygen enriched atmosphere (above 25% by volume). 9 Respirator selection must be undertaken by a competent person who is aware of the intended conditions of use. Only fit the
respirator under the supervision of a competent person. 9 If in doubt as to suitability of the equipment for the work to be undertaken, consult your supplier. 9 Before use, check that the mask is clean and in good condition. If you detect deterioration of valve diaphragms, or other rubber
components, replace immediately. 9 Check that the correct cartridge is fitted to suit the hazard and that all components are correctly assembled and in a clean condition. 9 Change the main filter cartridge frequently. The effective life of a main filter should be determined by a competent person who is
aware of the conditions of use. 9 Ensure you use recommended parts only, unauthorised parts may be dangerous and will invalidate any warranty. 9 Only when worn correctly fitted will the mask provide the prescribed degree of protection. 9 Ensure the face-piece fits comfortably on the face. WARNING! Mask may not fit correctly if facial hair passes under the face-seal. 9 Upon leaving the contaminated area, remove excess contamination from clothes before removing the respirator. 9 After each working period, the respirator must be cleaned and prepared for the next period of use. 8 DO NOT use detergents, thinners, solvents or petroleum-based disinfectant to clean the respirator. Clean the unit with warm soapy
water only. 8 DO NOT allow water to get into the main filter. 9 Care must be taken to ensure the rubber seal on the inside of the filter holder is not damaged. 9 Ensure you keep records of respirator maintenance. 9 When not in use, store the cleaned respirator in a sealed plastic bag in a clean, dry atmosphere out of direct sunlight and out of the
reach of children. Keep unit away from chemicals, abrasive substances and such that it cannot be damaged by physical contact with hard surfaces/items.
2. INTRODUCTION Lightweight and dermatologically friendly made from soft thermoplastic elastomer. Built-in exhalation vent makes breathing out easy and comfortable without letting harmful materials in. Threaded cartridges makes connecting filters easy and efficient. Adjustable straps in order to optimize comfort and support. S
3. SPECIFICATION MODEL NO: 9360......(Half Mask - No Cartridges) MODEL NO: 9360/61 (Half Mask with A1P2R Filter Cartridges) MODEL NO: 9360/62 (Half Mask with P3R Filter Cartridges) MODEL NO: 9360/63 (Half Mask with ABEK1 P2R Filter Cartridges) MODEL NO: 9360/66 (Half Mask with A2P3R Filter Cartridges) FILTER OPTIONS:
9360, 9360/61, 9360/62, 9360/63, 9360/66 Issue 1 06/09/21Original Language Version Jack Sealey Limited
Refer to instructions
Humidity to be less that 80%
Store between -5oC and 50oC
FILTER PART NUMBER
RATING PROTECTION MAXIMUM USER LEVELS
Qty.
9361 A1 P2R Organic Vapour and Particulate Pre-Filter
1000 ppm or 10 x OEL whichever is lower
2
9362 P3R Particle Filter 30 x OEL 2
9363 ABEK1 P2R OV/IO/AG/AM and Particulate Pre-filter
1000 ppm or 10 x OEL whichever is lower
2
9366 A2 P3R Organic Vapour and Particulate
5000 ppm or 30 x OEL whichever is lower
2