Philips AQ1001/05 AQ1001 Cassette Player User Manual PDF

1 of 10
1 of 10

Summary of Content for Philips AQ1001/05 AQ1001 Cassette Player User Manual PDF

Register your product and get support at AQ1001

User manual


Contents 1 Important 2

Safety 2

2 Your Cassette Recorder 3 Introduction 3 What's in the box 3

3 Get started 3 Carry the recorder 3 Install batteries 3 Connect power 4

4 Play 4 Play a cassette 4 Record from different sources 5

5 Other features 5 Listen through headphones 5

6 Product information 6 Specifications 6

7 Troubleshooting 7

8 Notice 7

2 EN

1 Important

Safety Heed all warnings and follow all

instructions. Do not use the device near water. Clean only with dry cloth. Do not block any ventilation openings.

Install in accordance with the manufacturer's instructions.

Do not install near any heat sources such as radiators, heat registers, stoves, or other devices(includingamplifiers)thatproduce heat.

Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the device.

Onlyuseattachments/accessoriesspecified by the manufacturer.

Unplug the device during lightning storms or when unused for long periods of time.

Referallservicingtoqualifiedservice personnel. Servicing is required when the device has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the device, the device has been exposed to rain or moisture, does not operate normally, or has been dropped.

Battery usage CAUTION To prevent battery leakage which may result in bodily injury, property damage, or damage to the device: Incorrect use of batteries can cause

electrolyte leakage and will corrode the compartment or cause the batteries to burst.

Old and new or different types of batteries should not be combined.

Install the battery correctly, + and - as marked on the device.

Remove battery when the device is not used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

The device shall not be exposed to dripping or splashing.

Do not place any sources of danger on thedevice(e.g.liquidfilledobjects,lighted candles).

Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable.


Never remove the casing of this device. Never place this device on other electrical equipment. Keep this device away from direct sunlight, naked flamesorheat.

Toreducetheriskoffireorelectricshock,donot expose this device to rain or moisture.

Ensure that you always have easy access to the power cord, plug, or adapter to disconnect this device from the power.


2 Your Cassette Recorder

Introduction With this cassette recorder, you can play a cassette and make a recording.

What's in the box

Qu ck start guide

3 Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your apparatus. The model number and serial number are on the bottom of your apparatus. Write the numbers here: Model No. __________________________ Serial No. ___________________________

Carry the recorder Pull out the handle to carry the recorder.

Install batteries


You can use both batteries and AC power as power supply of this device.

1 Open the battery compartment. 2 InsertfourCtypebatteries(notsupplied)

withcorrectpolarity(+/-)asindicated. 3 Close the battery compartment.



4 EN


The RECORD BATT lights when battery is low.

Connect power Caution

Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the unit.

Risk of electric shock! When you unplug the power adapter, always pull the plug from the socket. Never pull the cord.

Before connecting the power adapter, ensure that you have completed all other connections.

Use the supplied power adapter only.


4 Play

Play a cassette

1 Press STOP/EJECT to open the cassette door.

2 Load a cassette with the side to play facing up.

3 Push to close the cassette door. 4 Press to start play.

Control play Buttons Functions

Press both and to record. Start play. Rewind the tape. Search forward fast. Pause play.

Adjust volume



Record from different sources

1 Prepare the source. Build-in microphone: place the

recorder within 0 5m from the sound source.

External microphone: insert the microphoneplug(notsupplied)into the MIC jack. If the microphone has a remote control plug, connect it to the REM jack.

Audio source: connect an external audio device to the AUX jack through anAUX-INcable(notsupplied),and set the volume of the audio device to the desired level.

2 Press STOP/EJECT to load a blank tape. 3 Press RECORD and PLAY at the same

time to start recording. Both RECORD and PLAY lock down

and recording begins.


Do not force down RECORD if no tape is loaded. The VOLUME setting doesn't control the recording


4 Press STOP/EJECT to stop recording.


Recording stops automatically when the tape ends.

5 Other features

Listen through headphones Plug headphones into EAR socket on the left of the device.

Hearing safety Listen at a moderate volume. Using headphones at a high volume can

impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss.

Sound can be deceiving. Over time your hearing 'comfort level' adapts to higher volumes of sound. So after prolonged listening, what sounds 'normal' can actually be loud and harmful to your hearing. To guard against this, set your volume to a safe level before your hearing adapts and leave it there.

To establish a safe volume level: Set your volume control at a low setting. Slowly increase the sound until you can

hear it comfortably and clearly, without distortion.

Listen for reasonable periods of time: Prolonged exposure to sound, even

at normally 'safe' levels, can also cause hearing loss.

Be sure to use your equipment reasonably and take appropriate breaks.

Be sure to observe the following guidelines when using your headphones. Listen at reasonable volumes for

reasonable periods of time.

6 EN

Be careful not to adjust the volume as your hearing adapts.

Do not turn up the volume so high that you can't hear what's around you.

You should use caution or temporarily discontinue use in potentially hazardous situations. Do not use headphones while operating a motorized vehicle, cycling, skateboarding,etc.;itmaycreateatraffic hazard and is illegal in many areas.

6 Product information


Product information is subject to change without prior notice.


Amplifier Rated Output Power 0.4 W RMS Frequency Response 125-6300Hz Signal to Noise Ratio >45 dB Total Harmonic Distortion <1% Aux Input 0.6VRMS20kohm

General information Power Supply - AC Power Adaptor

- Battery

Model: KSAS3R 50600050VKD Input:100-240V~, 50/60Hz;0.15A Output:6.0V 0.5 mA 4 X C batteries

Operation Power Consumption 3 W Dimensions -MainUnit(WxHxD) 144x46x241mm Weight - With Packing - Main Unit

0.83 kg 0.64kg


7 Troubleshooting Warning

Never remove the casing of this device.

To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page ( Philips, make sure that the device is nearby and the model number and serial number are available.

No power Ensure that the AC power plug of the unit

is connected properly. Ensure that there is power at the AC

outlet. Insert the batteries with their polarities

(+/signs)alignedasindicated. Replace the battery.

No sound Adjust the volume.

No response from the unit Take out the batteries and turn on the unit

again. Disconnect and reconnect the AC power

plug, then turn on the unit again.

8 Notice Anychangesormodificationsmadetothis device that are not expressly approved by Philips Consumer Lifestyle may void the users authority to operate the equipment.

This product complies with the radio interference requirements of the European Community.

Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.

When this crossed-out wheeled bin symbol is attached to a product it means that the product iscoveredbytheEuropeanDirective2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.

Your product contains batteries covered by theEuropeanDirective2006/66/EC,which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries

8 EN

because correct disposal helps to prevent negative consequences for the environmental and human health. Recording and playback of material might requireconsent.SeeCopyrightAct1956and The Performers Protection Acts 1958 to 1972.

Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separateintothreematerials:cardboard(box), paperpulp(buffer)andpolyethylene(bags, protectivefoamsheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations

Manualsnet FAQs

If you want to find out how the AQ1001/05 Philips works, you can view and download the Philips AQ1001/05 AQ1001 Cassette Player User Manual on the Manualsnet website.

Yes, we have the User Manual for Philips AQ1001/05 as well as other Philips manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The User Manual should include all the details that are needed to use a Philips AQ1001/05. Full manuals and user guide PDFs can be downloaded from

The best way to navigate the Philips AQ1001/05 AQ1001 Cassette Player User Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Philips AQ1001/05 AQ1001 Cassette Player User Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Philips AQ1001/05 AQ1001 Cassette Player User Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Philips AQ1001/05 AQ1001 Cassette Player User Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Philips AQ1001/05 AQ1001 Cassette Player User Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.