Mitsubishi Motors MZ341010EX Installation Instructions PDF

1 of 6
1 of 6

Summary of Content for Mitsubishi Motors MZ341010EX Installation Instructions PDF

JI261316 09.8

(09B1349)

PAJERO / MONTERO (V60, V70, V80, V90) AIR FILTER (for Air-conditioner)

MZ341010EX (for right-hand drive vehicle) MZ341011EX (for left-hand drive vehicle)

INSTALLATION AND HANDLING INSTRUCTIONS

Thank you for purchasing the Mitsubishi Genuine Accessory. To install and use the product correctly with proper knowledge of it, read this publication carefully. Keep this manual for reference when maintenance is required.

This manual gives precautionary instructions in the boxes titled as follows. Read through these instructions thoroughly.

Describes precautions that should be observed in order to prevent injury or damage to the vehicle or its components, which may occur if sufficient care is not taken.

Provides additional information that facilitates installation work.

Failure to follow these instructions not only prevents the product from working properly but may lead to trou- ble with the vehicle. Be sure to follow all instructions carefully.

If there is anything unclear about the installation, handling and/or usage of the product, contact an authorized Mitsubishi Motors dealer for clarification.

Mitsubishi Motors Corporation is not responsible for any defects or difficulties caused by or resulting from the failure to follow given instructions.

We recommend you to have the installation performed at an authorized Mitsubishi Motors dealer.

Air filter

Attention

To the dealer: Be sure that the customer receives this manual.

Caution

Note

-2-

j TOOLS (Make the following tools ready for use.)

j COMPONENTS (Make sure that all of the following components were included in the kit.)

j PRECAUTIONS Be sure to apply the parking brake securely. Remove the ignition key from the key cylinder. To keep out dirt and dust, unpack this product just before installation. The drawings in the Installation Procedures depict the installation on the right-hand drive vehicle. Install on

the left-hand drive vehicle in the same manner.

Air filter: 1 Tapping screw (M4 16): 2 Inspection label: 1

Installation and Handling Instructions (this document): 1

Socket wrench (10 mm) Extension bar

Phillips screwdriver Utility knife

1 2 3

4

-3-

INSTALLATION PROCEDURES FOR V60 / V70 A. PRE-OPERATIONAL WORK

1) Remove the glove compartment in accordance with the workshop manual.

2) Confirm that this is the first time to install or replace the air filter. Check whether an air filter is already installed at the hatched section in the drawing with two tapping screws.

If this is a replacement work, remove and discard the old air filter and go to step B.

3) If this is the first installation, cut out the hatched section of the blower unit carefully along the groove on the unit.

4) After cutting, clean the inside of the blower unit and remove any cutting chips.

B. INSTALLING THE AIR FILTER 1) Install the air filter in the correct direction. The

AIR FLOW arrow mark on the air filter should be pointing downward.

2) Insert the air filter fully and fix it securely with two tapping screws .

Glove compartment

Clip

Remove the clip.

Blower unitCut out.

Stay bracket Vehicle harness Clip for securing vehicle harness

Air filter1

AIR FLOW

Tapping screw2

Clip for securing vehicle harness Blower unit 1

If the filter is installed upside down, it will not function properly.

Caution

1 2

Check

Check

-4-

C. FILLING IN THE INSPECTION LABEL

1) Reinstall the glove compartment.

2) Open the glove compartment and fill in the date of replacement, driving distance, and the replace- ment part number (shown below) on the inspection label. If there is no label, wipe clean the label attaching position on the glove compartment shown in the drawing and attach the inspection label . Replacement part number:

7803A028 (Left-hand drive model) 7803A027 (Right-hand drive model)

D. CHECKING AFTER INSTALLATION 1) Check that the air filter and the removed parts are installed securely.

Inspection label3

Glove compartment

3

Check

Check

-5-

INSTALLATION PROCEDURES FOR V80 / V90 A. PRE-OPERATIONAL WORK

1) Remove the glove compartment in accordance with the workshop manual.

2) Confirm that this is the first time to install or replace the air filter. Check whether an air filter is already installed at the hatched section shown in the draw- ing (with two tapping screws).

If this is a replacement work, remove and discard the existing air filter and go to step B.

3) If this is the first installation, cut out the hatched section of the blower unit carefully along the groove on the unit.

4) After cutting, clean the inside of the blower unit and remove any cutting chips.

B. INSTALLING THE AIR FILTER 1) Install the air filter in the correct direction. The

AIR FLOW arrow mark on the air filter should be pointing downward.

2) Insert the air filter fully and fix it securely with two tapping screws .

Glove compartment

Blower unit

Cut out.

Air filter1 AIR FLOW

Tapping screw2

Blower unit 1

If the filter is installed upside down, it will not function properly.

Caution

1 2

Check

Check

-6-

C. FILLING IN THE INSPECTION LABEL

1) Reinstall the glove compartment.

2) Open the glove compartment and fill in the date of replacement, driving distance, and the replace- ment part number (shown below) on the inspection label. If there is no label, wipe clean the label attaching position on the glove compartment shown in the drawing and attach the inspection label . Replacement part number:

7803A028 (Left-hand drive model) 7803A027 (Right-hand drive model)

D. CHECKING AFTER INSTALLATION 1) Check that the air filter and the removed parts are installed securely.

CARE AND HANDLING DESCRIPTION

This air filter is built into the air conditioning system to eliminate pollen, mites, exhaust gas, volatile organic compounds (VOC), and allergens from the cabin air.

This product removes dust in the air entering the cabin or recirculating in the cabin to keep the interior envi- ronment clean.

HANDLING PRECAUTIONS To keep out dirt and dust, unpack this product just before installation. Do not store this product in direct sunlight, or in hot and humid environments. This product is disposable, and cannot be cleaned and reused. If it becomes dirty, replace it with the specified

Mitsubishi Genuine air filter (Part No.: 7803A028 (left-hand drive model)/7803A027 (right-hand drive model)). This product should be replaced every year or after 15,000 km of driving whichever comes first. More fre-

quent replacement may be necessary depending on the usage environment. (For the maintenance interval, refer to the SERVICE BOOKLET.)

The airflow resistance of the air filter increases as it collects dust. If it is used for an extended period of time, the performance of the air conditioner will lower. Be sure to replace it periodically.

If you have any question about maintaining this product, ask an authorized Mitsubishi Motors dealer.

<

Manualsnet FAQs

If you want to find out how the MZ341010EX Mitsubishi MOTORS works, you can view and download the Mitsubishi Motors MZ341010EX Installation Instructions on the Manualsnet website.

Yes, we have the Installation Instructions for Mitsubishi MOTORS MZ341010EX as well as other Mitsubishi MOTORS manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Installation Instructions should include all the details that are needed to use a Mitsubishi MOTORS MZ341010EX. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Mitsubishi Motors MZ341010EX Installation Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Mitsubishi Motors MZ341010EX Installation Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Mitsubishi Motors MZ341010EX Installation Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Mitsubishi Motors MZ341010EX Installation Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the Mitsubishi Motors MZ341010EX Installation Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.