Logik L15BSS13 Instruction Manual PDF

1 of 2
1 of 2

Summary of Content for Logik L15BSS13 Instruction Manual PDF

Thank you for purchasing your new Logik Blender.

We recommend that you spend some time reading this instruction manual in order to fully understand all the operational features it oers.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

GB-4 GB-5

DSG Retail Ltd. (Registered in England no. 504877) Maylands Avenue, Hemel Hempstead, Hertfordshine, HP2 7TG, UK

Visit Partmaster.co.uk today for the easiest way to buy electrical spares and accessories. With over 1 million spares and accessories available we can deliver direct

to your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK customers only) Calls charged at National Rate.

This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste. There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product.

QSG-L15BSS13-130131V1

Instruction Manual

Blender L15BSS13

OPERATION

1. Make sure the jug and the lid are secure and in the Locked position.

2. Turn the Speed Dial to 0.

3. Plug your blender into the mains socket and switch on the power.

Do not run the appliance continuously for more than 3 minutes. After a full 3 minute cycle allow the blender to rest for another 5 minutes before using it again.

Operation

Select the desired operating speed. There are 2 speeds. Move the Speed Dial progressively to the right to increase the speed. When you start blending use a low speed to begin and gradually increase the speed if necessary.

To stop, turn the Speed Dial back to 0.

Use this mode when ingredients need to be blended in small repeated bursts.

Turn the Speed Dial to P and hold it there for a short time.

To stop the operation, release the Speed Dial will automatically return to 0.

Continuous (Normal)

Pulse

AFTER USE

After you have nished blending:

1. Set the Speed Dial to 0.

2. Hold the jug by the handle and carefully turn it clockwise (towards you) to release the jug. (This may be easier with one hand on the base and one hand holding the jug handle).

3. To pour out the contents, rotate the lid of the jug anticlockwise to free it and then lift o the lid. Pour or spoon the contents out carefully.

4. Unplug the blender from the mains socket.

Do not run the appliance continuously for more than 3 minutes. After a full 3 minute cycle allow the blender to rest for another 5 minutes before using it again.

Never blend very hot liquids in the blender. This is dangerous as the contents may erupt.

If you spill liquid on the blender base immediately switch o and wipe dry.

During blending, you can feed in small amounts of food or liquid through the jug lid. To do this:

1. Hold the lid.

2. Turn the stopper slowly anti-clockwise to free it and then lift it out.

3. Gradually feed pieces of food or liquids into the jug through the feeder.

4. Fit the stopper back when you have nished.

CLEANING

Cleaning the blender jug:

1. Pour about 500ml of warm soapy water into the jug and place the jug on the base.

2. Turn and hold the Speed Dial to P for a few seconds to loosen any food particles and free them from the blades.

Remove the jug, pour away the water and rinse in fresh running water. Repeat 1 and 2 with fresh water.

Alternatively the jug may be immersed in warm soapy water and cleaned using a long handled brush. Do not touch the blades when cleaning.

Wash the lid and stopper separately in warm soapy water, rinse and allow to dry.

DO NOT wash the jug or attachments in a dishwasher.

Cleaning the base: Ensure the blender is switched o and unplugged from the mains. Wipe the outer surface of the motor unit with a damp cloth. Never use abrasive

cleaners or scouring creams.

Always operate blender with cover in place.

The jug body should be handled carefully. The jug contains moving parts - do not leave the jug immersed in water for any longer than necessary to clean it or you may aect the operating performance of the blender.

STORAGE

After all the components have been washed and dried, re-assemble the blender and store it out of direct sunlight and out of the reach of children.

The cable may be wound around the lugs at the bottom of the appliance for easier storage.

SPECIFICATIONS

Power : 230V~50Hz, 450W Capacity of Jug : 1.5 litres max. Duty Cycle : 3 minutes ON; 5 minutes OFF

We continually strive to improve our products, specications may change without prior notice.

C

M

Y

CM

MY

CY

CMY

K

L15BSS13_IB_final_130131.pdf 1 31/01/2013 5:45 PM

GB-3GB-1

SAFETY FIRST!

Please follow all the safety precautions listed below for safety and to reduce the risk of injury or electrical shock. Read all the instructions carefully before using your appliance and keep them for future reference.

Unplug the appliance from the mains supply when not in use, when removing or attaching the blender jug, or before clean- ing any part of the appliance.

This appliance is for household use only. Do not use it for professional catering.

Do not use the appliance outdoors. Do not immerse the appliance base unit or the mains cable or plug in liquids.

Do not use the appliance near a source of heat or on an unstable surface.

Do not use your appliance in damp or wet conditions. Never let children operate this appliance. Close supervision is necessary when this appliance is used near children.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabili- ties, or lack of experience and knowledge, unless they have been given supervision or instructions concerning the use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Ensure that the mains cable does not touch any hot surface and that it does not overhang the edge of your work surface.

There are no user serviceable parts in your appliance. Do not operate the appliance with a damaged mains cable or mains plug or after the appliance or any attachment has been damaged. Seek qualied technicians for assistance.

If the mains cable is damaged it must be replaced by the manufacturer, its service agent, or similarly qualied persons in order to avoid a hazard.

Do not use attachments or accessories which are not recom- mended by the manufacturer. They may cause malfunction or injury.

Store the appliance away from direct sunlight and out of the reach of children.

When operating your blender: Do not place your hand in the blender jug. The sharp blade may cause injury.

Never insert any hard object or implement into the blender jug when it is operating. This may cause damage to the appli- ance and personal injury.

Do not place meat containing bones or fruits with large hard stones in the blender jug.

If the blender becomes clogged, switch o and unplug the mains cable from the mains socket before cleaning the obstruction. Check carefully for damage.

Do not use the appliance for any purpose not expressly speci- ed in this manual.

GB-2

If items are missing or damaged, please contact Partmaster (UK only). Tel: 0844 800 3456 for assistance.

* All images in this instruction manual are for indication only; please refer to your individual unit for details.

UNPACKING

Remove all packaging from the blender. Retain the packaging. If you dispose of it please do so according to any local regulations.

The following items are included:

The Base Unit Blender Jug

Blender Jug Cover Stopper

P 0 1 2

3

4

5

1500 1400 1300 1200 1100 1000 900 800 700 600 500

FIRST TIME USE

1. Before using your blender for the rst time, wash the jug, blade assembly, lid and stopper. Rinse throughly and dry.

2. Place the base unit on a stable surface, free from heat and moisture and within easy reach of a mains socket. The mains cable should not be taut.

PRODUCT OVERVIEW

P 0 1 2

3

4

5

Stopper

Mains Cable

Blade Assembly

Handle

Base Unit

Speed Dial

Fill Level

Safety Lid

1500 1400 1300 1200 1100 1000 900 800 700 600 500

PREPARING AND FILLING THE INGREDIENTS

1. Cut the ingredients into 25mm (1) cubes before placing them into the blender jug. If the food is very solid or dry, cut the pieces into smaller cubes.

2. Fill the blender jug with the ingredients.

3. Do not overfill the jug. The maximum capacity is 1500 ml. If you are preparing a large quantity use several smaller batches.

4. If the ingredients are very dry, put some liquid into the jug. You should never try to reduce dry ingredients in the blender.

FITTING THE LID

1. Place the lid on the top of the jug and pull the lid.

Always operate blender with cover in place.

FITTING THE JUG TO THE BASE UNIT

Place the jug on the blade assembly as shown. The jug will fit only one way round. If the jug is not properly tted to the base the blender will not start.

The lid must be secured to the jug and the jug to the base otherwise the blender will not operate!

FITTING THE STOPPER

The stopper has an integral measuring cup useful for measuring small amounts of ingredients.

Place the stopper in the s

Manualsnet FAQs

If you want to find out how the L15BSS13 Logik works, you can view and download the Logik L15BSS13 Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Logik L15BSS13 as well as other Logik manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Logik L15BSS13. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Logik L15BSS13 Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Logik L15BSS13 Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Logik L15BSS13 Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Logik L15BSS13 Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Logik L15BSS13 Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.