Hoover HCF 6185 TA User Manual PDF

1 IT

COMBINED TOTAL NO FROST AND FROST FREE EN

COMBINED FROST FREE

CONTROL PANEL Open the top door of the fridge in order to access the control panel.

MODEL WITH SUPER OPTION Turn on the knob to switch on the appliance and set the temperature of the freezer compartment and fridge.

We recommend you set the temperature to 2 or 3. Turn the knob to 0 to turn off the appliance.

The orange light comes on when the thermostat knob is

turned to SUPER. In this case the compressor continues to

function as normal.

The green ON light shows that the unit is working. This

light is on irrespective of the knob setting, except for when

the knob is set to 0.

SUPER ON

SUPER

ON

1

2 3

40

1 2

3

45

(Figure 1)

(Figure 2)

BASE MODEL Turn on the knob to switch on the appliance and set the temperature of the freezer compartment and fridge. We recommend you

set the temperature to 2 or 3. Turn the knob to 0 to turn off the appliance.

Important: Some appliances will start working at least 6 minutes after the plug has been inserted in the power outlet and the temperature has been set.

The green ON light shows that the unit is working. This

light is on irrespective of the knob setting, except for when

the knob is set to 0.

FREEZING The preservation of frozen foods is guaranteed in all of the freezers compartments.

In some products there is a section in the top part, (see quick guide).

MODEL WITH SUPER OPTION Place the foods to be frozen in the drawer , turn the thermostat clockwise to SUPER position, and the

orange light will come on (see gure 1). After 24 hours, freezing is completed. Therefore, reset the thermostat to position 2-3. The SUPER function

is automatically disabled from the circuit board after 26 hours. The rating plate states the maximum quantity of foods that can be frozen, (see

gure 3).

BASE MODEL Place the foods to be frozen in the drawer , freezing is guaranteed in any position of the knob (see gure 2). At the start

of the freezing process, so as not to make the fridge compartment excessively cold, it may be necessary to turn the thermostat knob back by

approximately 1/2 numbers, according to the load and room temperature. Once the freezing process is completed, return the thermostat knob

to the usual value.

N.B. For better air circulation, leave some room in between the foods and avoid blocking the cooling air outlets.

DEFROSTING

(Figure 3)

A small amount of frost or drops of water on the back of the fridge compartment when

the fridge is working is normal.

Make sure the water outlet is always clean. Make sure foods do not touch the back or

sides of the fridge compartment.

The freezer compartment does not require defrosting because this product is equipped

with an automatic system that prevents the formation of ice (frost free).

N.B. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the information on the plate.

Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit on the back of the fridge compartment. In this case, turn the knob to lower settings (1-2).

SUPER

1 2

3

4

2 EN

3 EN

REVERSING THE OPENING OF THE DOORS In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.

Place the appliance on the oor or at a 45

angle, since it is necessary to work on the

bottom of the appliance.

Remove the lower plinth by pulling out the

3 protective plugs and by loosening the

screws.

Drill the plinth on the marked left hand-side

area.

Take off the bottom right-hand hinge by

removing the screws, pin and washers, then

remove the lower door.

Remove the caps (A) and (B), loosen the

screws and partially remove the panel.

Unscrew the right hinge.

Mark and break the left-hand slot on the

panel, in the insert area.

Take the top left-hand hinge from the

accessories kit and fasten it.

Remount the hinges and doors working from

bottom to top 1 2 3.

Fit the panel, and secure with the screws and

caps.

To reverse the handles: remove the outer

caps from the right-hand side of the doors.

Unscrew the handles from the left-hand side

and move them to the right-hand side, then

position the outer caps on the left-hand side

of the doors.

Put the appliance in an upright position and

wait two hours before turning it on.

45

(A) (B)

3

2

1

2 Hours

FROST FREE PLUS The Frost Free Plus system use