Contents

Hoover FRHNL3505A-80 User Manual PDF

Download download
Hoover FRHNL3505A-80 User Manual PDF
Hoover Manual Hoover Refrigerator Manual Hoover AB HDC 6 Manual Hoover Refrigerator User Manual
Pages 5
Year 2006
Language(s)
English en
1 of 5
1 of 5

Summary of Content for Hoover FRHNL3505A-80 User Manual PDF

Page 2

1

FRIDGE GB

Page 3

2 GB

FRIDGE

CONTROL PANEL In order to access and adjust the temperature of the fridge it is necessary to turn the knob on the control panel. The thermostat box is located inside the fridge on the top right hand- side.

The appliance is turned off when the knob is set to 0. We recommend you set the temperature to 2 or 3.

DEFROSTING

The fridge compartment is automatically defrosted when the compressor is not working

Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit on the back of the fridge compartment. In this case it is necessary to turn the knob to lower settings

A small amount of frost or drops of water on the back of the fridge compartment when the fridge is working is normal

Make sure the water outlet is always clean. Make sure foods do not touch the back or sides of the fridge compartment

NB. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the information on the plate.

FREEZING The upper part of the appliance is a freezer compartment (see

Users quick guide). Foods must remain in this compartment for 24 hours

to be frozen properly.

N.B. If the freezer door is closed properly, the coloured door light will

not be visible.

VISIBLE INDICATOR: OPEN

NON-VISIBLE INDICATOR: CLOSED

Page 4

3 GB

A Place the appliance on the floor or at a 45 angle, as it is necessary to work on the bottom of the appliance.

Take off the bottom right-hand hinge by removing the screws, pin and washers, then remove the lower door.

Mark and break the left-hand slot on the panel, in the insert area.

Flip the top left-hand hinge found in the accessories kit.

Fit the panel, and secure with the screws and caps.

To reverse the handles: remove the outer caps from the right-hand side of the doors.

Remount the hinges and doors working from bottom to top,

Unscrew the handles from the left-hand side and move them to the right-hand side, then position the outer caps on the left-hand side of the doors.

Remove the lower plinth by pulling out the 3 protective plugs and by loosening the screws.

Remove the caps (A) and (B), loosen the screws and partially remove the panel.

Unscrew the right hinge.

Drill the plinth on the marked left hand-side area.

REVERSING THE OPENING OF THE DOORS In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.

Place the appliance on the floor or at a 45 angle, as it is necessary to work on the bottom of the appliance.

Mark and break the left-hand slot on the panel, in the insert area.

With another panel type, break the plastic membrane and screw the hinge on the left-hand side of the panel.

Screw the panel back on and place the outer label back on. Put the appliance in the upright position and wait two hours before turning it on.

To reverse the handles: remove the outer caps from the right-hand side of the doors.

Unscrew the handles from the left-hand side and remount them on the right-hand side of the product. Place the plugs on the left-hand side.

Insert the pin in the hinge and the spacer in the insert. Reassemble the hinges and doors working from bottom to top.

Remove the plug on the left-hand side and insert it on the right-hand side of the central and lower inserts. Invert the bushing in the lower insert.

With this panel type, remove the label and screws, then partially remove the panel.

Remove the screws from the top right hinge and invert the position of the pin, then reassemble it on the left-hand side.

Take off the bottom right-hand hinge by removing the screws, pin and washers, then remove the lower door.

Remove the lower plinth by pulling out the 3 protective plugs and by loosening the screws.

Drill the plinth on the marked left hand-side area.

1) break the plastic membrane

2) Insert the pin

spacer

bushing

plug

Put the appliance in an upright position and wait two hours before turning it on.

B

Put the appliance in an upright position and wait two hours before turning it on.

Page 5

Z STUDIO > 01-2006 41018262

In order to reverse the opening of doors, d

Manualsnet FAQs

If you want to find out how the AB HDC 6 Hoover works, you can view and download the Hoover FRHNL3505A-80 User Manual on the Manualsnet website.

Yes, we have the User Manual for Hoover AB HDC 6 as well as other Hoover manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The User Manual should include all the details that are needed to use a Hoover AB HDC 6. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Hoover FRHNL3505A-80 User Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Hoover FRHNL3505A-80 User Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Hoover FRHNL3505A-80 User Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Hoover FRHNL3505A-80 User Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Hoover FRHNL3505A-80 User Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.