GE RAKCDC External Fan Kit Installation Instructions PDF

1 of 4
1 of 4

Summary of Content for GE RAKCDC External Fan Kit Installation Instructions PDF

WIRING INSTRUCTIONS This kit can be wired for multiple functions. Unit can be connected to run the CDC only, external fan only, or CDC and external fan together. For correct wiring for each see below:

Recommended wire size must be followed as a minimum requirement.

Wire Size #AWG Maximum Allowable Length #22 600 Ft. #20 900 Ft. #18 1500 Ft. #16 2000 Ft.

TOOLS NEEDED Wire strippers

This kit is for use with 208/230v and 265v (AZ45 and AZ65 Series) GE Zoneline units only.

Pub No. 31-30755-2 08-16 GE

Installation Instructions for your new

Before you begin - Read these instructions completely and carefully. IMPORTANT OBSERVE ALL GOVERNING CODES AND ORDINANCES. Note to Installer Be sure to leave these instructions with the Consumer. Note to Consumer Keep these instructions with your Owners Manual for future reference.

RAKCDC CDC and External Fan Kit

PARTS INCLUDED (1) 3 Pin Connector Assembly (3) Wire Nuts

IMPORTANT NOTES All wiring must be in accordance with NEC, local

codes, ordinances and regulations. All wiring should be performed by a qualified

electrician.

Important CDC Comments (all series applicable): 1. When the switching device closes the circuit of the

conductors, the unit operation stops. 2. Do not use a common bus (at the unit or at the

switch panel) in the wiring. Both wires comprising the circuit must connect to the unit connectors and to the controlling switch. Running one wire from one unit to another unit is common busing and may damage internal components or cause erratic operation of the system.

3. A 24 volt transformer is contained within the Zoneline unit. No external voltage may be applied to the unit through the CDC terminals. (Voltage on the CDC conductors is 24 volt AC)

WARNING RISK OF ELECTRIC SHOCK. Disconnect the electrical power supply before wiring connections.

C D

C Sw

itch

C D

C

EXT FAN

C D

C Sw

itch

C D

C

EXT FAN

C D

C

EXT FAN C

onnect to External Fa n

C onnect to

External Fa n

R R R

1. Remove the room cabinet by pulling it out at the bottom to release it (1); then lift it up to clear the rail along the unit top (2).

2. Connect the CDC plug in appropriate connector on the control box cover, insuring the connector clip has engaged.

3. Wire according to desired function and secure with wire nuts, insuring no bare wires are visible.

4. Reinstall room cabinet insuring the clips are completely clipped in position.

Installation Instructions

Red Aux Set Button

CDC Connector

INSTRUCTIONS DE CBLAGE Cet ensemble peut tre cbl pour de nombreuses fonctions. Il peut tre connect pour faire fonctionner uniquement le CDC, un ventilateur externe uniquement ou un CDC et un ventilateur externe conjointement. Pour raliser le cblage adquat pour chaque application, reportez-vous ci-dessous :

La dimension de cble recommande doit tre suivie dune exigence minimum.

Dimen. de fil n AWG Longueur max. admissible

#22 600 pi

#20 900 pi

#18 1500 pi

#16 2000 pi

OUTILS REQUIS Outils dnuder

Cet ensemble est destin tre utilis uniquement avec les appareils GE Zoneline 208/230 V et 265 V (sries AZ45 et AZ65).

Pub No. 31-30755-2 08-16 GE

Instructions dinstallation pour votre nouvel ensemble de CDC et ventilateur externe

Avant de commencer - Lisez ces instructions attentivement et en entier. IMPORTANT RESPECTEZ TOUS LES CODES ET RGLEMENTS APPLICABLES. Remarque lintention de linstallateur - Assurez-vous de remettre ces instructions au client. Remarque lintention du client Conservez ces instructions avec le manuel du propritaire afin de pouvoir vous y reporter ultrieurement.

RAKCDC

PICES COMPRISES (1) Ensemble de connecteur 3 broches (3) Capuchons de connexion

REMARQUES IMPORTANTES Lensemble du cblage doit tre ralis conformment au

CNE, codes locaux, ordonnances et rglements. Lensemble du cblage doit tre ralis par un lectricien

professionnel.

Commentaires importants sur le CDC (applicables toutes les sries) : 1. Lorsque lappareil de connexion ferme le circuit des

conducteurs, le fonctionnement de lappareil sarrte. 2. Nutilisez pas un bus courant (au niveau de lappareil ou au

niveau du panneau dinterrupteurs) dans le cblage. Les deux fils qui constituent le circuit doivent se connecter aux connecteurs de lappareil et linterrupteur de commande. Faire passer un fil dun appareil un autre appareil constitue une interconnexion par bus courante qui pourrait endommager des composants internes ou entraner un fonctionnement imprvisible du systme.

3. 3. Le Zoneline intgre un transformateur de 24 volts. Aucune tension externe de doit tre appliqu lappareil par lentremise des bornes de CDC. (la tension sur les conducteurs de CDC est de 24 volts CA)

AVERTISSEMENT RISQUE DE DCHARGE LECTRIQUE. Dbranchez le bloc dalimentation avant de raliser les raccords.

Interrupteur de C D

C

C D

C

VEN T. EXT.

Inter. C D

C

C D

C

VEN T. EXT.

C D

C

VEN T. EXT.

Brancher Ventilateur externe

Brancher Ventilateur externe

R R R

1. Retirez larmoire en la tirant hors de la base pour la dgager (1), puis soulevez-la pour dgager le rail le long du haut de lappareil (2)

2. Branchez la fiche de CDC dans le connecteur appropri sur le couvercle de la bote de commande en vous assurant que lattache de connecteur est engage.

3. Le fil est install conformment la fonction souhaite et fix avec des capuchons de connexions en sassurant quaucun fil nu nest visible.

4. Rinstal

Manualsnet FAQs

If you want to find out how the RAKCDC GE works, you can view and download the GE RAKCDC External Fan Kit Installation Instructions on the Manualsnet website.

Yes, we have the Installation Instructions for GE RAKCDC as well as other GE manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Installation Instructions should include all the details that are needed to use a GE RAKCDC. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the GE RAKCDC External Fan Kit Installation Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This GE RAKCDC External Fan Kit Installation Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download GE RAKCDC External Fan Kit Installation Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print GE RAKCDC External Fan Kit Installation Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the GE RAKCDC External Fan Kit Installation Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.