GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 PDF

1 of 4
1 of 4

Summary of Content for GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 PDF

MATERIALS YOU WILL NEED

WARNING RISK OF FIRE

DETERMINE ELECTRICAL REQUIREMENTS FOR YOUR DRYER MODEL

208V AND 240V MODELS ARE NOT APPROVED FOR 120V INSTALLATION.

Installation Instructions (USA only) MODELS DSKS433 AND DSKS333 MUST BE INSTALLED WITH CONTROL PANEL AT BOTTOM IN ORDER TO OPERATE ADEQUATELY.

UNPACKING AND PREPARING FOR INSTALLATION

BEFORE YOU BEGIN Read these instructions completely and carefully.

IMPORTANT-

IMPORTANT- Note to Installer -

Note to Customer -

TOOLS YOU WILL NEED

SLIP JOINT PLIERS FLAT BLADE AND PHILLIPS SCREWDRIVERS

GLOVES

SAFETY GLASSES

DRYER POWER CORD KIT

(NOT PROVIDED WITH DRYER)

4" DUCT CLAMPS (2)

OR 4" SPRING

CLAMPS (2)

EXHAUST HOOD

3/4" STRAIN RELIEF UL RECOGNIZED4" DIA. METAL

ELBOW

4" DIA. FLEXIBLE METAL (SEMI-RIGID) UL LISTED TRANSITION DUCT (IF NEEDED) KIT WX08X10077 (INCLUDES 2 ELBOWS)

4" DIA. METAL DUCT (RECOMMENDED)

4" DIA. FLEXIBLE METAL (FOIL TYPE) UL LISTED TRANSITION DUCT (IF NEEDED.) DUCT TAPE

UL RATED 120/240V,30A WITH 3 OR 4 PRONGS. IDENTIFY THE PLUG TYPE AS PER THE HOUSE RECEPTACLE BEFORE PURCHASING LINE CORD.

234D1588P002 31-16687 01-12 GE

STACKING KITS FOR DRYERS (Comes with individual Installation Instructions)

Over washer - Use Wall Mount Kit WMK-35 or - Stack Rack DSDR24 or - Stack Rack DSR-24 For alcove and closet depth and width re uirements see speci c kit instructions All stacking kits are available from your local sales outlet.

Questions? Call: 800.GE.CARES (US) www.GEAppliances.com (US)

Printed in Mexico

FOR FOUR-WIRE SUPPLY (208V & 240V MODELS)

REAR

HOT WIRE

HOT WIRE

FRONT

208V or 240V

GREEN GROUNDING SCREW

WHITE NEUTRAL WIRE

GREEN OR YELLOW GROUND WIRE

L 1 L 2N

FOR THREE-WIRE SUPPLY (208V & 240V MODELS)

Typical 30 amp receptacle for use where local codes permit use of flexible type power supply cord (pigtail).

3 WIRE RECEPTACLE (10-30R)

REAR HOT WIRE

HOT WIRE

FRONT

208V or 240V

GREEN GROUNDING SCREW

WHITE NEUTRAL WIREGROUND

STRAP

L 1 L 2N

WARNING:

WARNING:

ELECTRICAL CONNECTION DETAILS OBSERVE ALL GOVERNING CODES AND ORDINANCES

DO NOT USE EXTENSION CORD WITH THIS APPLIANCE

GROUNDING INSTRUCTIONS

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

Typical 30 amp receptacle for use where local codes permit use of flexible type power supply cord (pigtail).

Typical 30 amp cord assembly for use where local codes do not permit grounding through neutral.

4-WIRE RECEPTACLE (14-30R) 4-CONDUCTOR CORD

ASSEMBLY ( Type ST Cable)

X

W G

Y

DRYER TOP VIEWIF YOUR DRYER COMES WITH REAR EXHAUST, TO CHANGE TO SIDE OR BOTTOM EXHAUST:

FOR SIDE EXHAUST:

FOR BOTTOM EXHAUST:

IF YOUR DRYER COMES WITH TOP EXHAUST, TO CHANGE TO SIDE OR REAR EXHAUST:

FOR SIDE EXHAUST:

FOR REAR EXHAUST:

EXHAUST INFORMATION WARNING - IN CANADA AND IN THE

UNITED STATES, THE REQUIRED EXHAUST DUCT DIAMETER IS 4 in (102mm). DO NOT USE DUCT LONGER THAN SPECIFIED IN THE EXHAUST LENGTH TABLE.

WARNING - BEFORE PERFORMING THIS EXHAUST INSTALLATION, BE SURE TO DISCONNECT THE DRYER FROM ITS ELECTRICAL SUPPLY. The correct exhaust installation is YOUR RESPONSIBILITY. Problems due to incorrect installation are not covered by the warranty.

MAXIMUM ALLOWABLE

EXHAUST SYSTEM CHECK LIST HOOD OR WALL CAP

SEPARATION OF TURNS

TURNS OTHER THAN 90

SEALING OF JOINTS

INSULATION

EXHAUST CONNECTION WARNING - TO REDUCE THE RISK

OF FIRE OR PERSONAL INJURY:

ALTERNATE EXHAUST INSTRUCTIONS

Left knockout

Bottom knockout

Right knockout

Blower

Fr on

t o f d

ry er

152 mm

203 mm (8)

89 mm (3)

6

For Rear Exhaust

For Side Exhaust

Rigid Metallic DuctingCut Here

EXTENSION DUCT

It is importat to replace the ground clip after cutting the exhaust duct, (on rear exhaust model)

295 mm

115 mm (4)

(11)

EXHAUST LENGTH CALCULATION RIGID (Preferred)

FLEXIBLE

ALCOVE OR CLOSET INSTALLATION

WARNING: TO PREVENT LARGE AMOUNTS OF LINT AND MOISTURE FROM ACCUMULATING AND TO MAINTAIN DRYER EFFICIENCY, THIS MACHINE MUST BE EXHAUSTED OUTDOORS.

NOTE TO INSTALLER - AFTER INSTALLATION CHECK THE FOLLOWING:

4" DIA.

4"

4" DIA.

2-1/2"

RECOMMENDED MAXIMUM LENGTH Exhaust Hood Types

Recommended

No. of 90 Elbows

Rigid Metal

Rigid Metal

14 m (46 ft) 11 m (37 ft) 9 m (30 ft) 7 m (23 ft)

11 m (37 ft) 9 m (30 ft)

6.5 m (22 ft) 4.5 m (15 ft)

0 1 2 3

Use only for short run installations

CONNECTING THE DRYER TO HOUSE VENT RIGID METAL TRANSITION DUCT

UL-LISTED FLEXIBLE METAL (SEMI-RIGID) TRANSITION DUCT

UL-LISTED FLEXIBLE METAL (FOIL-TYPE) TRANSITION DUCT

For best drying performance

NOTE: The clearances stated above are minimums. Con- sideration must be given to the type accessory kit used with dryer. Refer to the speci <

Manualsnet FAQs

If you want to find out how the DSKP333ECWW GE works, you can view and download the GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 on the Manualsnet website.

Yes, we have the Installation Instructions for GE DSKP333ECWW as well as other GE manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Installation Instructions should include all the details that are needed to use a GE DSKP333ECWW. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2, simply download the document to your computer. Once downloaded, open the PDF file and print the GE DSKS333 DSKP333ECWW Dryer Installation Instructions V2 as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.