Contents

GE GEFLSTACK Bracket Kit Installation Instructions PDF

1 of 8
1 of 8

Summary of Content for GE GEFLSTACK Bracket Kit Installation Instructions PDF

Stack Bracket Kit GEFLSTACK

Installation Instructions

FOR YOUR SAFETY:

WARNING Electric Shock Hazard. Disconnect power

before installing. Failure to do so could result in serious injury or death.

Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death.

Avoid Tipping and Rupture of Utility Services. Dryer must be securely attached to the washer. DO NOT place the washer on top of the dryer. Failure to do so could result in personal injury/death or property damage.

Mobile Home or Manufactured Home Installation Stacking of a gas dryer is not permitted in a mobile home or manufactured home.

175D1807P598 49-90330 05-07 JR

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT Save these instructions for local electrical inspectors use.

IMPORTANT Observe all governing codes and ordinances.

Note to Installer Be sure to leave these instructions with the Consumer.

Note to Consumer Keep these instructions for future reference.

Installation must be performed by a qualified installer.

Proper installation is the responsibility of the installer.

MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATION

Minimum clearance to combustible surfaces and for air opening are: 0 both sides and 1 rear. Consideration must be given to provide adequate clearance for installation and service.

ALCOVE OR CLOSET INSTALLATION

If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

The dryer MUST be vented to the outdoors. Refer to dryer Installation Instructions for details.

Minimum clearance between dryer cabinet and adjacent walls or other surfaces is: 0 either side 3 front and rear

Minimum vertical space from floor to overhead cabinets, ceiling, etc. is 43 without pedestal, 55 with pedestal and 84 stacked.

Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 square inches of open area equally distributed. If the closet contains both a washer and a dryer, doors must contain a minimum of 120 square inches of open area equally distributed.

2

Installation Instructions

REMOVE THE DRYER LEVELING LEGS

Carefully lay the dryer on its side. Use the packing material so you dont scratch the finish on the dryer.

Use an open-end wrench or pliers to remove the dryer leveling legs.

B

A

1

Back out and remove all 4 leveling legs

INSTALL RUBBER PADS TO DRYER BASE

Locate the 4 rubber pads in the parts package. Remove the adhesive backing and firmly place over on the bracket where you removed the levelling legs.

2

KIT CONTENTS

Right Hand Bracket

Left Hand Bracket

4 Rubber Pads

4 #12 x 1 Screws

4 #8 x 1/2 Screws

TOOLS YOU WILL NEED Phillips Screwdriver

Open Ended Wrench

Pliers

Gloves

Level

INSTALLATION PREPARATION

Remove the packaging. Flatten the product carton to use as a pad to lay the dryer down on its side. Continue using the carton to protect the finished floor in front of the installation location.

INSTALL DRYER AND BRACKET ON WASHER

Lift the dryer on top of the washer. Be careful not to scratch the top of the washer with the brackets. Protect the washer control panel with cardboard or other protection. Be sure to lift the dryer high enough to clear the washer control panel.

WARNING Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death.

Align the holes in the bracket with the holes in the back of the washer. Using a Phillips screwdriver attach the 2 #8 x 1/2 tapping screws. Repeat on both sides of the washer.

B

A

5

3

Installation Instructions

INSTALL BRACKET TO DRYER

Align the holes in the left bracket with the holes in the bottom left corner of the dryer. Use a Phillips screwdriver to install the 2 #12 x 1 tapping screws. Repeat the above step with the right bracket on the bottom right corner of the dryer.

Set the dryer upright.

NOTE: Make sure to set the dryer on a piece of packing material so the brackets that are attached to the bottom of the dryer do not damage the floor.

C

B

A

3

PREPARE THE WASHER AND DRYER

Place the washer in the approximate location. Make sure the washer is level. Refer to washer Installation Instructions for details. Remove the back portion of the control panel by removing the 3 screws. Reverse dryer door swing if desired. See dryer installation instructions for details.

NOTE: The washer door swing is not reversible.

D

C

B

A

4

4

Installation Instructions

Printed in China

FINALIZE THE INSTALLATION

Refer to the washer Installation Instructions to complete the washer installation. Refer to the dryer Installation Instructions to complete the dryer installation. Carefully slide or walk the stacked washer and dryer into place. Use felt pads or other sliding device to assist moving and to protect flooring.

WARNING Potential Personal Injury. Do not push on the dryer once installed to top of the washer. Pushing on the dryer may result in pinched fingers.

C

B

A

6

Place hands here

Place hands here

Trousse de fixation de superposition

GEFLSTACK

Instructions dinstallation

POUR VOTRE SCURIT :

AVERTISSEMENT Danger de choc lectrique. Coupez le courant avant

linstallation. Le non-respect de ces instructions pourrait mener des blessures ou la mort.

Blessure personnelle possible. Il est recommand davoir plus de deux personnes pour soulever la scheuse en place cause de son poids et de sa taille. Le non-respect de ces instructions pourrait mener des blessures ou la mort.

vitez de pencher et de briser les services publics. La scheuse doit tre bien fixe la machine laver. NE placez PAS la machine laver sur la scheuse. Le non-respect de ces instructions peut mener des blessures personnelles/la mort ou aux dommages la proprit.

Installation dans les maisons mobiles ou les maisons manufactures il nest pas permis de superposer une scheuse gaz dans une maison mobile ou manufacture.

175D1807P598 49-90330 05-07 JR

AVANT DE COMMENCER

Lisez toutes ces instructions attentivement et en entier.

IMPORTANT Conservez ces instructions pour linspecteur local de llectricit.

IMPORTANT Observez tous les codes et ordonnances en cours.

Note linstallateur Assurez-vous de laisser ces instructions au consommateur.

Note au consommateur Conservez ces instructions titre de rfrence.

Linstallation doit se faire par un installateur qualifi.

Une bonne installation est la responsabilit de linstallateur.

DGAGEMENT MINIMUM AUTRE QUUNE INSTALLATION EN ALCVE OU DANS UN PLACARD

Le dgagement minimum pour les surfaces combustibles et pour louverture dair est de : 0 cm des deux cts et 2,54 cm larrire. Il faut prvoir un dgagement adquat pour linstallation et lentretien ou la rparation de lappareil.

INSTALLATION EN ALCVE OU DANS UN PLACARD

Si votre scheuse est approuve pour une installation en alcve ou dans un placard, cela sera indiqu larrire de la scheuse.

La scheuse DOIT tre vacue vers lextrieur. Reportez-vous aux instructions dinstallation de la scheuse pour les dtails.

Le dgagement minimum entre larmoire de la scheuse et les murs adjacents ou toutes autres surfaces est de : 0 cm dun ct ou lautre et de 7,6 cm lavant et larrire.

Lespace vertical minimum du plancher aux armoires suspendues, au plafond, etc. est de 109 cm sans socle, 140 cm avec socle et 213 cm en modle superpos.

Les portes de placard doivent tre persiennes ou ventiles dune autre faon et doivent avoir au moins 387 cm despace ouvert rparti uniformment. Si le placard contient la fois une laveuse et une scheuse, les portes doivent avoir au moins 774 cm despace ouvert rparti uniformment.

2

Instructions dinstallation

RETIREZ LES PIEDS DE NIVELLEMENT DE LA SCHEUSE

Dposez avec soin la scheuse sur le ct. Utilisez le matriau demballage pour ne pas gratigner le fini de la scheuse.

Utilisez une cl ouverte ou une pince pour retirer les pieds de nivellement de la scheuse.

B

A

1

Sortez et retirez les 4 pieds de nivellement

OUTILS DONT VOUS AUREZ BESOIN Tournevis Phillips

Cl ouverte

Pince

Gants

Niveau

PRPARATION DE LINSTALLATION

Retirez lemballage. Dfaites le carton du produit pour lutiliser comme coussin o dposer la scheuse sur le ct. Continuez utiliser le carton pour protger le plancher fini devant le site dinstallation.

CONTENU DE LA TROUSSE

Fixation droite

Fixation gauche

4 coussinets de caoutchouc

4 vis n 12 x 2,54 cm

4 vis n 8 x 1,27 cm

3

Instructions dinstallation

INTALLEZ LES COUSSINETS DE CAOUTCHOUC LA BASE DE LA SCHEUSE

Trouvez les 4 coussinets de caoutchouc dans le paquet de pices. Retirez lendos adhsif et placez fermement sur la fixation o vous avez retir les pieds de nivellement.

2

INSTALLEZ LA FIXATION LA SCHEUSE

Alignez les trous de la fixation gauche avec les trous dans le coin infrieur gauche de la scheuse. Utilisez un tournevis Phillips pour installer les 2 vis auto taraudeuses n 12 x 2,54 cm. Rptez ltape prcdente avec la fixation droite dans le coin infrieur droit de la scheuse.

Relevez la scheuse.

REMARQUE : assurez-vous de dposer la scheuse sur une pice demballage pour que les fixations fixes au bas de la scheuse nendommagent pas le sol.

C

B

A

3

PRPAREZ LA MACHINE LAVER ET LA SCHEUSE

Placez la machine laver son emplacement approximatif. Assurez-vous que la machine laver soit niveau. Reportez-vous aux instructions dinstallation de la machine laver pour les dtails. Retirez la partie arrire du panneau de contrle en retirant les 3 vis. Inversez louverture de porte de la scheuse, si vous le dsirez. Reportez- vous aux instructions dinstallation de la scheuse pour les dtails. REMARQUE : Louverture de la porte de la machine laver nest pas rversible.

D

C

B

A

4

4

Instructions dinstallation

Imprim en Chine

INSTALLEZ LA SCHEUSE ET LA FIXATION SUR LA MACHINE LAVER

Soulevez la scheuse sur la machine laver. Attention de ne pas gratigner le dessus de la machine laver avec les fixations. Protgez le panneau de contrle de la machine laver avec du carton ou tout autre type de protection. Assurez-vous de soulever la scheuse assez haut pour dgager le panneau de contrle de la machine laver.

AVERTISSEMENT Blessure personnelle possible. Il est recommand davoir plus de deux personnes pour soulever la scheuse en place cause de son poids et de sa taille. Le non-respect de ces instructions pourrait mener des blessures ou la mort.

Alignez les trous de la fixation avec les trous larrire de la machine laver. Utilisez un tournevis Phillips pour installer les 2 vis auto taraudeuses n 8 x 1,27 cm. Rptez des deux cts de la machine laver.

B

A

5 FINALISEZ LINSTALLATION

Reportez-vous aux instructions dinstallation de la machine laver pour terminer linstallation de la machine laver. Veuillez vous reporter aux instructions dinstallation de la scheuse pour terminer linstallation de la scheuse. Glissez ou portez avec soin la machine laver et la scheuse superpose en place. Utilisez des coussinets de feutre ou autre dispositif de glissement pour aider dplacer lappareil et protger le plancher.

AVERTISSEMENT Ble

Manualsnet FAQs

If you want to find out how the GEFLSTACK GE works, you can view and download the GE GEFLSTACK Bracket Kit Installation Instructions on the Manualsnet website.

Yes, we have the Installation Instructions for GE GEFLSTACK as well as other GE manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Installation Instructions should include all the details that are needed to use a GE GEFLSTACK. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the GE GEFLSTACK Bracket Kit Installation Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This GE GEFLSTACK Bracket Kit Installation Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download GE GEFLSTACK Bracket Kit Installation Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print GE GEFLSTACK Bracket Kit Installation Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the GE GEFLSTACK Bracket Kit Installation Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.