Keep these instructions for future reference as they contain important information. REQUIRED TOOL: PHILLIPS SCREWDRIVER (NOT INCLUDED).
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modications not expressively approved by the manufacturer responsible for compliance could void the users authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. CET APPAREIL NUMERIQUE DE LA CLASSE B EST CONFORME A LA NORME NMB-003 DU CANADA.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Lutilisation de ce produit est sujette aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolrer tout brouillage reu, mme si ce brouillage est susceptible de compromettre son fonctionnement.
1. Slide the switch to the desired play mode. The switch is located on the bottom of Doras skates, next to the battery compartment.
3. Press the button on Doras boot to begin play.
4. When she finishes a routine, press again for the next routine.
3 different dancing patterns in 3 different positions equals 9 different skating routines!
Conga line with Dora in front
Conga line with Boots in front
Works on most hard, at surfaces. If you pick Dora up while she is skating, her wheels will stop rolling.
She will resume skating when you put her back down again. If the toy is not played with for 15 seconds it will automatically shut-o to preserve battery life.
Press the button on Doras boot to resume play.
ID. X7237-0920
There are 2 ways to play with Skate & Spin Dora & Boots:
2. Position Dora and Boots in one of three ways:
HOW TO PLAY
DANCE Dora and Boots will move in three different dancing patterns with music.
FREE PLAY Music plays as you skate Dora and Boots around to create your own routines!
NOTE:
Holding one hand
BATTERY INSTALLATION: Unscrew and lift away cover from bottom of product. Replace batteries as indicated inside the battery compartment. Batteries included are for demonstration purposes only. For longer life use only alkaline batteries. If this toy begins to operate erratically, you may need to reset the electronics. Remove the batteries from the toy and replace them. Requires 4 "AA" (LR6) batteries.
BATTERY SAFETY INFORMATION In exceptional circumstances batteries may leak uids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the product before being charged. Rechargeable batteries are only to be charged under adult supervision. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Do not mix old and new batteries. Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the product. The supply terminals are not to be short-circuited. Dispose of battery(ies) safely. Do not dispose of this product in a re. The batteries inside may explode or leak.
Item No : X7237 Version : US Size : A4 Paper : 100% Recycled Paper, 70 gsm Color : Black Date : 19 Mar, 2013 (Vita Luo)