Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual PDF

1 of 6
1 of 6

Summary of Content for Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual PDF

Soothing Bouncer Seat Model Numbers: 79240, 79241, 79242, 79344, 79345, 79347, 79387

Please save these instructions for future reference.

Adult assembly is required.

Requires one size D (LR20) alkaline battery (not included).

To prevent serious injury and/or falls: Never use on any elevated surface. Never use as a carrier or lift while child is seated. Always use the restraint system. Never leave child unattended. Never use as a car seat. Never use with a child able to sit upright, unassisted.

WARNING

OFF ON

Fisher-Price

Place the base tube on a flat surface as shown. Position the left and right base wires as shown. Insert the left base wire into the base tube, until the red

mark on the left base wire is covered by the base tube. Insert the right base wire into the base tube, until the red

mark on the right base wire is covered by the base tube.

Base TubeRight

Base Wire

Left Base Wire

Red Marks

Parts

Right Base Wire

Pad with Canopy

Left Base Wire

Base Tube

Footrest Wire with Soothing Unit

Seat Back Wire

Message to Parents Thank you for purchasing the Fisher-Price Soothing Bouncer Seat. The Soothing Bouncer Seat requires adult assembly. Please read these instructions thoroughly and identify all parts before assembly. If you have any questions about this product, please call Fisher-Price Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 5 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Or write to: Fisher-Price Consumer Affairs, 636 Girard Avenue, East Aurora, New York 14052.

Assembly

2

Canopy Stays

1

O F

F O

N

OFF ON

Fisher-Price

Position the pad so that the cut-out is toward the soothing unit.

Locate the large upper pocket on the back of the pad. Slide the pad pocket over the seat back wire.

Pad Soothing Unit

Cut-out

Turn the Soothing Bouncer Seat frame on its side with the unconnected seat back and base wires facing up, as shown.

Push down on the unconnected seat back wire and fit it onto the right base wire until the red mark on the right base wire is covered by the seat back wire.

Turn the Soothing Bouncer Seat frame upright. Make sure the seat back wire is securely attached to the left and right base wires.

Right Base Wire Seat Back Wire

Red Mark

4

5

Assembly

OFF

Position the footrest wire with the soothing unit upright. Hook the footrest wire onto the ends of the left and right

base wires.

Footrest Wire with Soothing Unit

Left Base Wire

Position the seat back wire above the ends of the left and right base wires as shown. Make sure the seat back wire bends backward.

Fit one end of the seat back wire onto the left base wire, until the red mark on the left base wire is covered by the seat back wire.

Seat Back Wire

Left Base Wire

Red Mark

Right Base Wire

3

2

3

-+

SHOWN ACTUAL SIZE

1.5V D (LR20)

Lift the front of the pad to locate the small lower pocket. Lift the footrest wire with soothing unit. Fit the pad pocket onto the footrest wire with soothing unit. Lower the footrest wire with soothing unit.

Assembly is now complete.

Footrest Wire with Soothing Unit

Small Lower Pocket

Assembly

Battery Installation

4

Loop Loop

Helpful Hint: Before assembling the lower portion of the pad to the footrest wire with soothing unit, you may want to install the battery in the soothing unit. Please see the next section (Battery Installation) for instructions.

6

Battery Compartment Door

Insert a coin into the the battery compartment door and pry the battery compartment door open.

Insert one size D (LR20) alkaline battery, as indicated inside the battery compartment. Be sure to place the battery on top of the ribbon.

Helpful Hint: For easy battery removal, simply lift the ribbon. Replace the battery compartment door and be sure it snaps

securely closed. Fit the pad onto the footrest wire with soothing unit. Lower the footrest wire with soothing unit. PLEASE NOTE: Remove the battery during long periods of non-use. Never

leave a worn-out battery in this product. Battery leakage and corrosion may damage the this product. Dispose of the battery safetly.

Do not attempt to recharge a non-rechargeable battery. Remove the rechargeable battery from this product

before recharging. Charging of a rechargeable battery should only be done under

adult supervision. Avoid short-circuiting the terminals of the battery. Remove the exhausted battery from this product.

Battery Installation

Lift the footrest wire with soothing unit. Remove the pad from the footrest wire with soothing unit.

Footrest Wire with Soothing UnitPad

This product requires one, size "D" (LR20) alkaline battery.

OFF ON

Make sure your child is properly secured in the Soothing Bouncer Seat.

Slide the ON/OFF switch on the soothing unit to the ON position.The seat will vibrate.

Slide the ON/OFF switch on the soothing unit to the OFF position.The seat will not vibrate.

Soothing Vibration

To prevent serious injury and/or falls: Never use on any elevated surface. Never use as a carrier or lift while child

is seated. Never leave child unattended. Never use as a car seat.

WARNING

5

Securing Your Child

To prevent serious injury and/or falls: Always use the restraint system. Never use with a child able to sit

upright, unassisted.

WARNING

OFF ON

Place your child in the Soothing Bouncer Seat. Position the restraint between your childs legs.

Fasten both belts to the buckles on each side of the restraint. Make sure you hear a click on both sides.

Make sure the restraint is securely attached by pulling it away from your child.The restraint should remain buckled.

Restraint

Buckle Buckle

The canopy can be adjusted down or up. Fasten the snap on each side of the canopy when using the

canopy in the raised position.

Fisher-Price

OFF ON

OFF ON

Fisher-Price

Canopy Down

Canopy Raised

Snap

Snap

To remove the pad: Lift the footrest wire with soothing unit and remove the

pad bottom pocket. Slide the pad upper pocket off of the seat back frame.

Remove both canopy stays from the canopy sleeves. To re-assemble the pad: Replace both canopy stays into the canopy sleeves. Refer to assembly steps and .

Care The pad is machine washable.Wash the pad separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly. The wire frame may be wiped clean using a mild cleaning solution and a damp cloth.

Lift the footrest wire with soothing unit and remove the pad lower pocket.

Slide the pad upper pocket off the seat back frame. Remove the seat back wire from the left and right base wires. Remove the footrest wire with soothing unit from the left and

right base wires. Remove the battery from the soothing unit. Remove the left and right base wires from the base tube. Store all parts in a safe place for future use.

Storage One Year Limited Warranty Fisher-Price, Inc.,636 Girard Avenue,East Aurora,New York 14052, warrants that the Soothing Bouncer Seat is free from all defects in material and workmanship when used under normal conditions for a period of one (1) year from the date of purchase. Should the product fail to perform properly,we will repair or replace it at our option, free of charge.Purchaser is responsible for shipping the product to Fisher-Price Con-sumer Affairs at the address indicated above and for all associated freight and insurance cost.Fisher-Price, Inc.will bear the cost of shipping the repaired or replaced item to you.This warranty is void if the owner repairs or modifies the product.This warranty excludes any liability other than that expres-sly stated above including but not limited to any incidental or consequential damages. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH MAY VARY FROM STATE TO STATE.

6

Canopy

Sleeves

Canopy Stays

If you have any questions about this product: In Canada, call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2. In Great Britain, telephone 01628 500303. In Australia, Mattel Aust

Manualsnet FAQs

If you want to find out how the Mattel Fisher Price works, you can view and download the Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Fisher Price Mattel as well as other Fisher Price manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Fisher Price Mattel. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Fisher Price Mattel Soothing Seat 79345 Bouncer Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.