Summary of Content for Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual PDF
The above diagram shows a typical band setup... Microphones and instruments are plugged into separate channels... An external ef- fects processor is connected to the Insert jacks as described in the Power Amp Insert - Further Explanation section under Ex- ternal Loop Back Configuration... Finally a 1270P powered moni- tor takes advantage of the Monitor Line Out jack...
tion at 5... Use a microphone (or other source) in the same po- sition as it will be used on stage and in the same manner in which it will be used for the event... Start out with Feedback Killer off, then slowly turn up the channel input level control to the desired level (see Peak Indicator section on the next page)... Be ready to quickly turn down the level if you hear the onset of feedback or howling... Some environments may require that you engage Feed- back Killer to obtain the desired volume level... Repeat this for each input channel... Once each channel level has been set, you can adjust the volume of all channels together using the Left and Right Master Volume controls...
MIC/LINE SWITCH - Set this switch to the MIC position for lowimpedance microphones, phantom powered microphones, and very low-level input signals... Set the switch to the LINE po- sition for highimpedance microphones and highlevel signals... Al- ways turn down the corresponding channel level control before pressing the MIC/LINE switch to prevent a loud outburst...
Digital Effects can be used to en- hance the sound quality of any per- formance where appropriate and de- sired... Keep in mind that while Re- verb or effects can enhance a musi- cal performance or presentation, too much can make the same per- formance unintelligible or muf- fled... Keep your audience in mind when setting effects levels...
POWER AMP INSERTS - These jacks provide a connection for an equal- izer, or other external equipment... Each jack accepts a TRS (Tip/Ring/Sleeve) plug with Send=Tip, Return=Ring and Ground=Sleeve... When nothing is connected to the Power amp insert, the PD500 operates normally, with the mixer signal going directly to the internal PD500 amplifier...
POWER SOCKET and FUSE HOLDER - Connect the Power Socket to a grounded AC outlet using the provided IEC power cord... To replace the main fuse, unplug the power cord from the unit, then pry the fuse holder out from the power socket
PPPP oooo rrrr tttt aaaa bbbb llll eeee SSSS oooo uuuu nnnn dddd SSSS yyyy ssss tttt eeee mmmm
The POWER LED does NOT illuminate: Switch the Power OFF, then check the pow- er connections and retry... If the Power LED still does NOT illuminate, disconnect all ca- bles and check the fuse (see FUSE HOLDER above)... If the Power LED still does NOT il- luminate after 5 seconds, turn off the sys- tem and take the Passport to an authorized Fender Service center...
If you want to find out how the Passport PD-500 Fender works, you can view and download the Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual on the Manualsnet website.
Yes, we have the Owner's Manual for Fender Passport PD-500 as well as other Fender manuals. All you need to do is to use our search bar and find the user manual that you are looking for.
The Owner's Manual should include all the details that are needed to use a Fender Passport PD-500. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.
The best way to navigate the Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.
This Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.
You can download Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.
To be able to print Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Fender Passport PD-500 069-1007-000 120VAC 60Hz USA-CAN Sound System Owner's Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.