DeLonghi HSX2320 Series Instruction Manual PDF

1 of 7
1 of 7

Summary of Content for DeLonghi HSX2320 Series Instruction Manual PDF

DeLonghi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com 57 11

31 03

51 /0

5. 15

_0 0

HSX2320 Series

CONVECTOR

Instructions for use

2 3

A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below.

WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.

B) If your appliance is not fitted with a plug, please follow the instructions provided below:

Important The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

ELECTRICAL CONNECTION (UK ONLY)

Important - This appliance is Class II. If you have a 3-pin plug, do not connect any wire to the earth terminal.

3

1 2 C

200mm

200mm 75mm800mm 200mm

500mm

A

B

3

4 5

IMPORTANT INFORMATION Safety Warnings

Danger! Failure to observe the warnings may result in life-threatening injury by electric shock. - The appliance must not be placed

immediately below a power socket. - Do not use the heater close to bath,

wash-basin, shower and swimming pool.

- If the power cable has been damaged, it must be replaced by the manufacturer or the service centre or by an expert staff member so as to avoid all risks.

Important! Failure to observe the warning could result in injury or damage to the appliance.

- The appliance can be used by children at least 8 years old and by persons with reduced physical, mental and sensory capacities or with inadequate experience and knowledge, as long as they are carefully supervised or instructed on how to safely use the appliance and the hazards involved. Make sure that children do not play with the appliance. Cleaning and maintenance performed by the user must not be performed by children without supervision.

- Children less than 3 years old should be kept away from the appliance unless continuously supervised.

- Children between 3 and 8 years old may only switch the appliance on and off, provided that it has been placed or installed in its normal operating position, they are carefully supervised and instructed concerning use of the appliance in a safe way and they

understand the hazards involved. Children between 3 and 8 years old should not insert the plug, adjust and clean the appliance or perform maintenance on it. ATTENTION: Some parts of the appliance can become very hot and cause burns. Pay particular attention when children and vulnerable persons are present.

- ATTENTION: to avoid any danger caused by an accidental reset of the safety system, this appliance must not be powered through an external timer.

- Do not use the appliance in small rooms when they are occupied by persons that are not capable of leaving the room on their own, unless constant supervision is provided.

Danger of burns! Failure to observe these warnings may cause burns. - ATTENTION: to avoid overheating, do

not cover the appliance for any reason during operation, this w o u l d c a u s e d a n g e r o u s overheating.

- Extension leads should not be used as it could overheat during operation of the appliance.

Note: This symbol indicates recommendations and important information for the user. - Never use the appliance to dry laundry. - Do not place the power cable on the appliance when it is

hot. - For greater efficiency position the device away from

draughts. - Only use the heater in an upright position. - The appliance must be positioned at a minimum

distance of 80 cm from curtains or other movable objects sensitive to heat.

- The first time you use the appliance it may emit smells. It is advisable to let it run for at least 15 minutes with the thermostat at the maximum setting and then ventilate the room. A little smoke may be emitted due

5

to the protective substances applied to the heating element before transport.

- Do not position the appliance on deep-pile carpets or rugs, to avoid obstruction to the air intake grille located under it.

- Do not obstruct the hot air outlet grille or the air intake grille on the bottom of the appliance.

- Position the appliance so that the plug and the power socket can be easily reached after installation.

- Do not use this appliance in a room whose surface area is less than 4 m2.

- The appliance is fitted with a safety cutoff device which will switch the appliance off in case of accidental overheating. To reset the cutoff, disconnect the plug from the power supply for a few minutes, remove the cause of overheating then reconnect the appliance.

If this abnormal situation happens several times, contact customer service.

This appliance conforms to the following EC directives: - Low Voltage Directive 2006/95/EC and subsequent

amendments - Directive 2004/108/EC on electromagnetic compatibility

(EMC) and subsequent amendments

Use in compliance with intended use Use this heater only as described in this manual. All other use is considered improper. This appliance is not suitable for commercial use. The manufacturer is not liable for damage deriving from improper use of the appliance. This is a household appliance only. It is not intended to be used in: staff kitchen areas in shops, offices and other working

environments; farm houses; by clients in hotels, motels and other residential type

environments; bed and breakfast type environments. Use in this manner will invalidate the manufacturers warranty.

Disposing of the appliance The appliance must not be disposed of with household waste but must be taken to an authorised waste separation and recycling centre.

Fundamental recommendations regarding safety Dear Customer The plug on this appliance will get warm during use, this is perfectly normal. This product is A HIGH POWER HEATING APPLIANCE designed to our usual high standards but please make sure your wall

sockets are in good condition and the plug is inserted correctly to avoid any accidental overheating. We suggest that you check the plug AND THE SOCKET regularly if the heater is in prolonged use, if you are in any doubt please consult an electrician.

DESCRIPTION A Switches B Thermostat

USE General instructions Remove the appliance from the packaging. Check that neither the appliance nor the power cable has been damaged during transport. Do not operate the heater if damaged. Remove all publicity material from the appliance. The appliance is only suitable for use on the floor.

Electrical connection - Before connecting the appliance to the power socket,

check that the voltage indicated on the appliance rating plate is the same as your electrical system and that it can support the power consumption (Watt) indicated.

- If more than one appliance is used at the same time, it is important to ensure that the electrical system is able to support the power required.

Assembly of the feet Tools required: Screwdriver PH2x100 (crosshead) 2 supplied screws 3.5x13 PH (C) Place the appliance on a stable surface. For mounting the feet, proceed as follows: - Insert the two hooks in the slots and rotate the foot until

it is engaged as shown in figure 1. - Insert the two pins in their respective holes. - Fix the foot with the screw (C) supplied (figure 2). - Observe the minimum distances for the appliance from

the walls as shown in Figure 3. The measurements are indicated both for models equipped with fan " " and for models without.

Important! never use the appliance without the feet attached.

USE Operation and use To switch on the appliance turn the thermostat knob (B) clockwise up to maximum position 6, then press the switches:

6 TM

To select minimum power press the button MIN (the red LED will light up on the button).

To select medium power press the button MED (the red LED will light up on the button).

To select maximum power MAX press both buttons MIN and MED.

To turn off the appliance completely press the two switches to OFF (the red LEDs will go out), rotate the thermostat (B) to , then remove the plug from the power socket.

Models with fan The appliance is equipped with a fan that provides even more rapid and uniform heating. The fan comes on when MED or MAX power is selected.

Adjusting the thermostat When the room has reached the required temperature, turn the thermostat knob (B) slowly anticlockwise until you hear a click and no further. The LEDs of the switches will go out. The temperature will be automatically maintained by the thermostat. In spring or autumn or on mild days, you can save energy by using minimum power.

Freezing protection With the knob of the thermostat (B) in position and one of the power levels selected, the appliance will maintain the room at a temperature of about 5C preventing freezing with minimum energy consumption.

MAINTENANCE Before carrying out any maintenance, disconnect the appliance from the mains and wait for it to cool down completely. This appliance requires no particular maintenance. It is sufficient to remove dust with a soft, dry cloth. Never use abrasive powders or solvents. If necessary remove areas of concentrated dirt with a vacuum cleaner.

TECHNICAL CHARACTERISTICS Power supply See appliance rating plate Power consumption "

PROBLEM CAUSE SOLUTION

The appliance doesnt work

The plug is not inserted properly into the pow- er socket or the socket switch is off.

Check for any obstruction.

The switches are OFF.

The thermostat is set too low.

Insert the plug into the power socket and switch on if necessary.

Remove the obstruction, disconnect the power plug of the heater and let the ap- pliance cool down. If the problem per- sists, contact customer experience.

Press the switc

Manualsnet FAQs

If you want to find out how the HSX2320 Series DeLonghi works, you can view and download the DeLonghi HSX2320 Series Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for DeLonghi HSX2320 Series as well as other DeLonghi manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a DeLonghi HSX2320 Series. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the DeLonghi HSX2320 Series Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This DeLonghi HSX2320 Series Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download DeLonghi HSX2320 Series Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print DeLonghi HSX2320 Series Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the DeLonghi HSX2320 Series Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.