Currys Essentials C16LDIB11 Quick Start Guide PDF

1 of 2
1 of 2

Summary of Content for Currys Essentials C16LDIB11 Quick Start Guide PDF

Optimum Viewing Angles

Reception and Tuning Tips

Power Saving Function

Power Up Time

Thank you for purchasing your new Currys Essentials TV.

Your new TV incorporates the latest technology to enhance your viewing experience. We would suggest that you allow about 20 mins for initial setup.

Please follow this guide for a successful rst time installation.

The diagrams below demonstrate the optimum viewing angles for this TV.

This TV is tted with the latest eco friendly power saving technology, which will save power consumption. If you do not wish to use this functionality please follow the instruction manual (Time Setting Section). Please be aware that this functionality will cause this TV to switch o after 4 hours if no remote keys are pressed.

3. Now adjust the alignment and position of your aerial until you get the best picture. The ideal alignment would be approximately in line with your outdoor aerial.

1. If you intend to use an indoor aerial, we recommend that you connect the TV to your main (outside) aerial for the rst tuning.

Indoor Aerial

2. Once tuning has nished, set your TV channel to BBC1, then move your TV to it's required location, connect the indoor aerial and switch on.

Portable Aerial

Side View Top View

Getting The Best From Your New Small Screen TV

16 LED BACKLIT LCD TV

QUICK START GUIDE C16LDIB11

15 15

45

45

There is a short delay when you power up your TV, this is normal. Check that the standby light switches from red to green, and wait for the screen to load.

15 Seconds

red

green

In some areas your signal strength will be weak.

C16LDIB11_QSG_Running Change_120816_Annie.pdf 1 12816 2:00

Unpacking1

Installing the Base Stand3 Connecting to the Mains Socket5

Connecting the Aerial4 Turning the TV On for the First Time6 Target Region Descriptor7

Operating Your Remote Control2

Target Region Setting

Country Code GBR

Primary Region England

Secondary Region

Tertiary Region

London Do not connect the TV to the mains supply until you have completed all the connections.

HDMI1 USB PC AUDIO PC IN RFSCART

1. Lay the TV down on a at surface with the back side facing up. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed beneath the screen.

2. To install the base stand, align the screw hole and then secure the base stand by hand or using a screwdriver with the provided 1 screw.

1. Press and lift the back cover up to open the battery compartment of the remote control.

2. Insert two AAA size batteries. Close the battery compartment cover.

Screw A (P.N.: 20912223101)

TV Front

screw

screw

OR

Base Stand Front

Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the RF (75) socket at the rear right side of your TV.

1. Connect the mains adapter to the mains socket after you have completed all the connections.

2. At this stage, the TV switches to standby mode. The red LED indicator will illuminate on the front panel of the TV.

3. In standby mode, press the button on the right side panel of the TV or on the remote control to turn the TV on. The red LED indicator will turn green.

Well done, your new TV is now ready to use. You will nd that there are many exciting features available. To get to know all these features, please take some time to read the instruction manual provided with your TV.

If after reading the instruction manual you have additional questions related to the use of your TV please call our UK Call Centre on 0844 561 1234. Our UK Customer Contact Centre is open Monday-Saturday 8am-8pm or Sunday 8am-6pm.

(P.N.: 4033C163613)

During tuning your TV may have received signals from more than one transmitter. If this has occurred the Target Region Descriptor screen will be displayed. This will enable you to select the correct regional transmission for the local news service that you require.

Press the buttons to adjust each option's setting and then press the OK button to conrm.

This will be shown as GBR for the UK.

This will show the regional country (e.g. England, Wales, Scotland, NI).

This will allow you to set the region for your local news service.

You may receive signals from more than one transmitter within the Secondary Region, (e.g Beds and Cambs may have Luton or Sandy Heath).

Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to any local regulations.

TV

Base Stand

Remote Control / AAA Batteries x 2

Mains Adapter

Instruction Manual

Quick Start Guide

Screw A

SCART Adapter Cable

The rst time you turn the TV on, it will go straight into First Time Installation.

Channel Tuning

TV : 3 Channel(s) DTV : 0 Channel(s) Radio : 0 Channel(s) Data : 0 Channel(s)

36%... 668.75MHz (TV)

Please press MENU to skip.

4. Channel tuning will commence. This operation may take up to 6 minutes. The display will show the progress of the tuning and the number of channels found.

Make sure the (+) and ( - ) ends of the batteries match the (+) and ( - ) ends indicated in the battery compartment.

The screw holes will only align if the front of the base stand is at the front of the TV.

RF Coaxial Cable (not included)

OR

VIDEO L R Y Pb Pr

HDMI2

To mains socket

Mains Adapter (included)

1. Press the OK button to start First Time Installation.

First Time Installation

Please ensure aerial is plugged in!

Then press OK button.

2. Press the buttons to select English as your desired language to be displayed on the menu. Press the OK button to conrm.

Dansk

Deutsch

Hrvatski

Italiano

OSD Language

OK

Magyar

Nederlands

Norsk

PolskiEnglishCesky

E k

Espanol~

Fran ais

Portugues

Pycck

3. Press the buttons to select UK as the country where you will operate the TV. Press the OK button to conrm.

France

Greece

UK

Australia

Austria

Czech

Denmark

Finland

Country

OK

Manualsnet FAQs

If you want to find out how the C16LDIB11 Currys Essentials works, you can view and download the Currys Essentials C16LDIB11 Quick Start Guide on the Manualsnet website.

Yes, we have the Quick Start Guide for Currys Essentials C16LDIB11 as well as other Currys Essentials manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Quick Start Guide should include all the details that are needed to use a Currys Essentials C16LDIB11. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Currys Essentials C16LDIB11 Quick Start Guide is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Currys Essentials C16LDIB11 Quick Start Guide consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Currys Essentials C16LDIB11 Quick Start Guide free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Currys Essentials C16LDIB11 Quick Start Guide, simply download the document to your computer. Once downloaded, open the PDF file and print the Currys Essentials C16LDIB11 Quick Start Guide as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.