Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions PDF

1 of 8
1 of 8

Summary of Content for Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions PDF

OPERATION & MAINTENANCE INSTRUCTIONS

ORIGINAL INSTRUCTIONS DL0722 - ISS 3

16 VENTILATION FAN MODEL NO: CAM400 (230V)

PART NO: 3230240

2 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE Ventilation Fan which is designed for indoor use in an industrial environment.

Read this manual carefully, in doing so you guarantee the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.

SAFETY RULES

Make sure that you read, understand and comply with the following rules.

POSITIONING This fan is designed for indoor use only.

Be aware that the suction capability is considerable. Do not position the fan where it will blow dust, chips or hazardous fumes at people.

DO NOT place the fan close to any wet surface. DO NOT place against any surface such as a wall, door or furniture etc.

DO NOT place the fan on a raised surface or anywhere it could topple over.

Only use the fan in a level position.

Take care to ensure that the intake grille cannot be blocked by curtains or other fabrics. Do not allow loose clothing, long hair, jewellery etc. to be drawn into the intake side of the fan.

DO NOT operate the fan in explosive atmospheres such as in the presence of flammable liquids, gases or dust such as in a paint spray booth. Electric motors create sparks which may ignite dust or fumes.

DO NOT cover the fan or obstruct the air inlet and outlet sections of the ventilator.

DO NOT get the fan wet or use in areas of high condensation.

DO NOT allow the power cable to touch hot surfaces.

ALWAYS make sure the brakes are engaged before operating.

DO NOT operate without the safety grills secured in position.

PERSONNEL SAFETY DO NOT use the fan when you are tired or under the influence of alcohol, drugs or intoxicating medication.

DO NOT stand on the fan.

3 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DO NOT use with wet hands or when there is water on the power cable.

Young children must be kept away unless continuously supervised.

ELECTRICAL SAFETY Inspect the power cable/plug for damage/looseness. Do not use the fan if the power cable is damaged.

Make sure that the voltage on the product label is the same as the voltage of the power supply. If in doubt, consult a qualified electrician.

DO NOT abuse the electrical cable. Do not use the cable for pulling or unplugging the fan.

Keep the cable away from sources of heat, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of electric shock.

DO NOT use extension cables with this fan.

SERVICE & REPAIRS Check that the fan is in good working order. Take immediate action to have it repaired or any damaged parts replaced.

DO NOT attempt to repair the fan yourself. Always contact the Clarke service department who will use recommended parts only. Unapproved parts may be dangerous and will invalidate your warranty.

ENVIRONMENTAL RECYCLING POLICY By purchasing this product, the customer is taking on the obligation to deal with its safe disposal in accordance with the Waste Electrical and Electronic Equipment regulations (WEEE).

In effect, this means that this product must not be discarded with general household waste but according to the laws governing Waste Electrical and Electronic Equipment (WEEE) at a recognized disposal facility.

GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused, tampered with, or not used for the purpose for which it was intended.

Faulty goods must be returned to their place of purchase, no product can be returned to us without prior permission.

This guarantee does not effect your statutory rights.

4 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved BS 1363 plug or a suitably fused isolator switch.

If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below. The old plug must be discarded safely, as insertion into a power socket could cause an electrical hazard.

If the colours of the wires in the power cable do not agree with the markings on the plug.

Connect the BLUE wire to the terminal marked N.

Connect the BROWN wire to the terminal marked L.

Connect the YELLOW AND GREEN wire to the terminal marked E or .

AN APPROVED RESIDUAL CURRENT DEVICE (RCD) WHICH HAS A TRIPPING CURRENT OF LESS THAN 30 mA MUST BE USED. If you are not sure, consult a qualified electrician. DO NOT try to do any repairs yourself.

BEFORE USE

Before commencing assembly, check for damage and or shortages etc, any damage or shortage should be reported to your Clarke dealer where the fan was purchased.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: BLUE = NEUTRAL BROWN = LIVE YELLOW AND GREEN = EARTH

Plug must be BS1363/A approved.

Always fit

Ensure that the outer sheath of

Neutral (Blue)

Live (Brown)

Earth (Green and

a 13 Amp

the cable is firmly held by the clamp

fuse. Yellow)

5 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Your ventilation fan should be supplied with the following parts:

4 x castors (2 with brakes)

16 bolts, 16 nuts, 16 spring washers and 32 flat washers.

Bolt the castor assemblies to the frame as shown using the fastenings supplied. Install the castors with brakes at one end of the frame.

This ventilator can be used with CLARKE 16 diameter retractable ducting available in 5 metre lengths as follows:

Orange (3230241) or Yellow (3230484)

1. Before use, attach the ducting to the discharge end of the ventilator as shown, secured with the tie cord provided.

2. Place the ventilator in a level position on a flat surface and at a safe distance from flammable materials.

3. Connect the ventilator to a suitable power outlet. The ventilator is operated by the ON/OFF switch.

4. Set the angle of tilt as required using the hand knob shown.

5. Always apply the brakes before operating the ventilator.

CARE & MAINTENANCE

Clean the with a soft damp cloth, Do not use solvents or abrasives.

If used in spaces with high dust content, clean the guards and fan blades by vacuuming or wiping. Remove the end guard to gain access to the blades by removing the four securing screws.

REPLACE GUARDS BEFORE RE-CONNECTING TO MAINS SUPPLY.

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE PERFORMING ANY CLEANING OR MAINTENANCE TASKS. REPAIRS SHOULD BE CARRIED OUT BY THE CLARKE SERVICE DEPARTMENT.

6 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

No other maintenance is required, should you discover any problem with the ventilation fan return it to the CLARKE service department for repair.

Should the fan fail to operate, check the power supply and that the fuse in the plug has not blown. Abnormal noise while the fan is running may occur if the fan is not standing on a level surface.

SPECIFICATIONS

Model CAM400

Product dimensions 575 x 435 x 770 mm

Air Inlet Size 16 inch

Drum diameter 480 mm

Fan diameter 395 mm

Swivel/tilt range 360o

Product Weight 37 kg

Operating temperature 10 - 40oC

Power supply 230V/50Hz

Duty Cycle Classification: S1 (continuous)

Ingress protection class IP54

Electrical insulation class I

Fan speed@optimum efficiency 2800 rpm

Rated airflow: (m3/h) 63 m3/m (3796 m3/h)

Total Pressure 700 Pa

Static pressure 436 Pa

Rated motor input power 1200 W

Overall efficiency 59.52%

Measurement catagory C

Efficiency catagory (static/total) Static

Efficiency Grade (at optimum energy point) 40

Guaranteed Sound Power Level 79 dB

Specific Ratio

Manualsnet FAQs

If you want to find out how the 3230240 Clarke works, you can view and download the Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions on the Manualsnet website.

Yes, we have the Operation and Maintenance Instructions for Clarke 3230240 as well as other Clarke manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Operation and Maintenance Instructions should include all the details that are needed to use a Clarke 3230240. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the Clarke 3230240 CAM400 230V 16 Inch Ventilation Fan Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.