Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual PDF

Pages 17
Year 2005
Language(s)
English en
1 of 17
1 of 17

Summary of Content for Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual PDF

Page 3

the battery power is low... Replace both batteries in such a case... (3) In cold temperatures, using size-AA lithium batteries is recommended... (4) Although lithium batteries work well in low temperature, their performance will

Page 4

This device complies with Part 15 of the FCC Rules... Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation... Do not make any changes or modifications to the equipment unless otherwise specified in the instructions... If such changes or modifications should be made, you could be required to stop operation of the equipmet... This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules... These limits are designed to provide reasonable protection against harmful interference in a residential installation... This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications... However, there is no guarantee that interference will not occur in a particular installation... If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna... Increase the separation between the equipment and receiver... Connect the equipment into an outlet on a circuit different from that to which

Page 5

zz Do not forcefully pull or extend the O-ring... zz The O-ring is specially treated... Be careful not to apply grease or allow oil to accidentally come into contact with it... zz Do not remove the O-ring... That may result in scratching the surface, allowing water to enter... zz If the O-ring is broken, cut or distorted, or if more than two years have passed since you purchased the binoculars, bring them to a Canon Service Center to have the O-ring replaced... It is recommended to replace the O-ring every two years (for a fee)... zz If you use the binoculars in a sandy or dusty environment, it is recommended to replace the O-ring every year...

Page 6

The 52mm filter (sold separately) can be attached to the filter attachment thread...

Page 7

The eyepiece lens caps and the objective lens caps can be placed on top of each other when they are not being used... Push the objective lens caps against the eyepiece lens caps...

Page 8

The strap is designed to hang on the neck in a specific direction... Install the strap in a manner so that the Canon logo at the center of the strap appears as in the illustration when the strap is hanging from the neck...

Page 9

zz Change batteries when the binoculars are dry and there is no moisture or dirt... zz Be careful not to let moisture onto the inner side of the battery chamber cover or into the chamber... If there is moisture, make sure to remove it and adequately dry it off before changing batteries... zz Wet batteries may result in battery leakage and failure...

Page 10

Adjust the width of the binoculars... zz Look through the binoculars and adjust the angle of the eyepieces until the left and right images converge... zz Doing the above maximizes performance and minimizes eye fatigue while viewing... zz When adjusting the width of the binoculars to suit the width between your eyes, look at a distant object...

Page 11

zz Then look with the right eye only at the same object while turning the dioptric correction ring until the object looks sharp...

Page 12

zz The Image Stabilizer may not be able to compensate for severe shaking... zz If the binoculars are attached to a tripod, it will compensate for the small vibrations unique to tripod use... zz If the binoculars face down for more than 10 seconds, such as when they are hanging from the strap, the Image Stabilizer will turn off to conserve power... To use the binoculars in downward direction, keep pressing the Image Stabilizer switch... zz When the battery power is low, the Image Stabilizer may generate noise and vibration... The image stabilization is not affected by this... zz Even without batteries loaded, the binoculars can still be used as is...

Page 13

If there is sand or dirt on the binoculars, wash them with water by following the procedure below... zz Never operate any functions while washing the binoculars with water... Otherwise water may leak into the binoculars through movable components, resulting in malfunction... zz Make sure that the battery chamber cover is closed before washing the binoculars... zz Use tap water below 30C/86F for washing...

Page 14

If there is a problem with the binoculars, first refer to the table below to see if you can resolve it... If the problem cannot be resolved, take the binoculars to your nearest Canon Service Center...

Page 15

Operating environment Temperature: 10C to 45C / 14F to 113F Humidity: 90%

Page 16

This product should be handed over to a designated collection point, e... g... , on an authorized one-for-one basis when you buy a new similar product or to an authorized collection site for recycling waste electrical and electronic equipment (EEE) and batteries and accumulators... Improper handling of this type of waste could have a possible impact on the environment and human health due to potentially hazardous substances that are generally associated with EEE... Your cooperation in the correct disposal of this product will contribute to the effective usage of natural resources... For more information about the recycling of this product, please contact your local city office, waste authority, approved scheme or your household waste disposal service or visit www... canon-europe... com/weee, or www... canon-europe... com/battery...

Manualsnet FAQs

If you want to find out how the IMAGE STABILIZER Canon works, you can view and download the Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Canon IMAGE STABILIZER as well as other Canon manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Canon IMAGE STABILIZER. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Canon IMAGE STABILIZER 10X42L IS WP Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.