Wear safety glasses and gloves while performing these instructions (steps 1 to 5). WARNING
Cut a 27/8" x 1" hole in a wall, at a convenient location for the control. See figure at right.
Temporarily place the control over the hole and mark both mounting screw hole positions.
Remove the control, drill both screw holes (3/16 ) in wall and insert the wall anchors (included).
Unplug the ventilation unit.
VC0195
Mount the control to the wall.
The button works following this sequence: Click 1 = 20 min Click 2 = 40 min Click 3 = 60 min Click 4 = OFF and so on The indicator lights up as per the selected duration and the system exchanges air at MAX speed. If the humidity sensor detects a humidity rise, the exhaust fan will activate in MAX speed for a 20-minute, a 40-minute or a 60-minute period as per the Automatic Auxiliary Control setting.
23850 rev. 01
!
This auxiliary control must be paired with the Advanced Touchscreen Control.
3/16", typ.
VC0206A
Plug the ventilation unit.
Keep the auxiliary control in hand. Go to the main control. Reach the Wireless Connection screen (see figure at right) following this path: HOME PAGE (press on the gear at the bottom right)\SETTINGS\ INSTALLATION\WIRELESS CONNECTION. Press on the auxiliary control button for 5 seconds. The LED indicator will fade in and out to indicate the system is trying to pair the auxiliary control with the main control. The main control will detect the item. This procedure will take 30 s max. Press on + to complete pairing. Once the pairing is done, the item will move in the upper part of the screen and a will appear at the left of the item.
NOTE: It is possible to unpair an item by pressing on x.
VC0207A
WIRELESS CONNECTION
If needed, reach the Automatic Auxiliary Control screen (see figure at right) following this path: HOME PAGE (press on the gear at the bottom right)\ PREFERENCES\AUTOMATIC AUXILIARY CONTROL to modify the humidity detection feature.
AUXILIARY CONTROL
VC0208A
SENSITIVITYSENSITIVITY
INSTALLATION AND USER GUIDE FOR 20-40-60 DELUXE CONTROL (PART NO. VBATHBTW)
READ AND SAVE THESE INSTRUCTIONS
The illustrations in this document are generic; your control appearance may be slightly different from the ones shown.
INSTALLATION
NOTE: If the control is to be installed in an electric box, go to step .
HOW TO USE THE CONTROL
MTest the wall control.
VC0188
If a batteries change is required, the low batteries indicator will flash for 5 seconds when pressing on the button.
Perform step to access the batteries. Remove the old batteries. Dispose of used batteries as per local rules and regulations. Replace the batteries. The use of rechargeable batteries is not recommended. Perform step L to install the auxiliary control back in its support.
VO0291
Disengage the control from its support by lifting and tilting the bottom part of the control.
NOTE: This wall control requires 2 AAA 1.5 V batteries (included).
Install the batteries at the back of the control.
VO0292
LInstall the auxiliary control back in its support. Insert the top brackets in the notches. Push on the bottom part of the control until it clicks in place.
HOW TO CHANGE THE BATTERIES
TROUBLESHOOTING
PROBLEM CAUSE
No detected item on Wireless Connection screen
The batteries are not installed
Low batteries
LED indicator does not light up when pressing on the button
The batteries are not installed
Low batteries
Range too high between the auxiliary control and the main control
Humidity sensor does not work Low batteries
Sensitivity too low, set sensitivity to High in the Automatic Auxiliary Control screen