Contents

Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide PDF

1 of 2
1 of 2

Summary of Content for Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide PDF

90 01

64 30

19

(0 20

40 2)

S

M S

4H C

W 40

G

* 9 0 0 1 6 4 3 0 1 9 *

Q ui

ck r

ef er

en ce

g ui

de

D is

hw as

he r

en Before using for the first time, read the instruction manual and the safety information it contains.

Setting up Home Connect

Tip: Connect your appliance to a mobile device. You can con- veniently change all settings using the Home Connect app.

1. Install the Home Connect app on your mo- bile device and follow the instructions.

2. Scan the QR code with the Home Connect app.

Overview of water hardness settings You can find an overview of the water hardness values that can be selected here. A table of country-specific units can be found in the instruction manual.

Hardness range

mmol/l Setting value

Soft 0 - 1.1 H00 Soft 1.2 - 1.4 H01

Medium 1.5 - 1.8 H02 Medium 1.9 - 2.1 H03 Medium 2.2 - 2.9 H04 Hard 3.0 - 3.7 H05 Hard 3.8 - 5.4 H06 Hard 5.5 - 8.9 H07

Setting the water softening sys- tem 1. Press . 2. To open the basic settings, press

for 3 seconds. a The display shows Hxx. a The display shows . 3. Press repeatedly until the right

water hardness has been set. 4. To save the settings, press

for 3 seconds.

Adding special salt To avoid damage to the appliance, only add special salt to the dispenser for special salt just before the programme starts. 1. Unscrew the lid of the dispenser for special salt

and remove. 2. On initial start-up: Fill the dispenser right up with

water.

3. Add the special salt to the dispenser. The water in the dispenser is displaced and forced out. Never add de- tergent.

4. Place the lid back on the dispenser and turn to close.

Adding rinse aid 1. Press the catch on the lid

of the dispenser for rinse aid and lift .

1

2

2. Add rinse aid up to the max mark.

max

3. Close the lid of the dispenser for rinse aid. a The lid clicks into position.

How to use your appliance 1. Load the tableware.

Only clean tableware that is suitable for dish- washers. Remove large remnants of food from the tableware. Check that the spray arms can ro-

tate freely. 2. Add detergent. 3. Switch on the appliance .

4. Select the programme. 5. Start the programme . 6. Remove the tableware at the end of the pro-

gramme.

7. To cancel the programme, press for approx. 4 seconds. The programme is cancelled and ends after ap- prox. 1 minute.

Programmes The programme data has been meas- ured in the laboratory according to European standard EN 60436. The consumption figures depend on the programme and additional func- tion selected. The runtime will change if the rinse aid system is switched off or rinse aid needs to be added.

Programme 1) Duration [h:min] 2) Energy [kWh] 3) Water [l]

Intensive 70

1) 2:05 - 2:15 2) 1,300 - 1,400 3) 11,5 - 14,0

Auto 45-65

1) 1:40 - 2:45 2) 0,900 - 1,500 3) 7,0 - 15,5

Eco 50

1) 4:55 2) 0,849 3) 9,5

Silence 501

1) 4:00 2) 1,050 3) 11,0

Express 65 - 1h

1) 1:00 2) 1,300 3) 10,5

Machine Care

1) 2:10 2) 1,350 3) 15,2

Favourite

1) 0:15 - 0:15 2) 0,050 - 0,050 3) 4,0 - 4,0

1 Suitable programme for running at night: it takes longer, but is extremely quiet.

Adding detergent 1. Add the detergent to the

dry detergent dispenser. 15 ml 25 ml 50 ml 2. Close the lid of the deter-

gent dispenser. a The lid clicks into position.

Cleaning filters 1. After each wash check the filters for

residue. 2. Turn the coarse

filter anticlock- wise and re- move the filter system .

1

2

3. Pull down the mi- cro filter to re- move.

4. Press the locking catches to- gether and lift the coarse filter out .

1

2

5. Clean the filter elements under running water.

6. Re-assemble the filter system. 7. Insert the filter system into the appliance

and turn the coarse filter clockwise. Make sure that the arrow markings match up.

Cleaning spray arms 1. Unscrew the upper spray arm and

pull down to remove . 1

2

2. Pull up the lower spray arm to remove.

3. Check the outlet nozzles on the spray arms for blockages un- der running water and remove any foreign bodies.

4. Insert the lower spray arm. a The spray arm clicks into position. 5. Insert the upper spray arm and screw it firmly in place.

Clean wastewater pump 1. Disconnect the appliance from the power supply. 2. Remove the filter system. 3. Scoop out any water. 4. Prise off the pump cover using a

spoon and grip it by the crosspiece.

5. Lift the pump cover inwards at an angle and remove. 6. Remove any remnants of food and foreign bodies in the area

of the impeller. 7. Insert the pump cover and press

down . a The pump cover clicks into position. 1

2

8. Install the filter system.

Troubleshooting

Fault Cause and troubleshooting E:32-00 will light up al- ternately or indicator for water supply lights up.

Supply hose is kinked. Install the supply hose without kinks.

Water tap is turned off. Turn on the water tap.

Water tap is jammed or furred up. Turn on the water tap.

The flow rate must be at least 10 l/min when the water sup- ply is open.

The filters in the water connection of the supply or AquaStop hose are blocked. 1. Switch off the appliance. 2. Pull out the mains plug. 3. Turn off the water tap. 4. Unscrew the water connection. 5. Remove the filter from the sup-

ply hose

6. Clean the filter. 7. Re-insert the filter in the supply hose. 8. Screw the water connection back on. 9. Check the water connection for leaks. 10.Restore the power supply. 11.Switch the appliance on.

Fault Cause and troubleshooting E:92-40 will light up al- ternately.

Filters are soiled or blocked. Clean the filters.

E:61-02 will light up al- ternately.

Wastewater pump is blocked. Clean the wastewater pump.

Cover of the wastewater pump is loose Secure the cover of the Wastewater pump so it clicks into

position.

Remnants of food on tableware.

Tableware is placed too close together or basket is overfilled. 1. Arrange tableware with sufficient space in between.

The spray jets must reach the surfaces of the tableware. 2. Avoid points of contact.

Spray arm rotation is blocked. Arrange tableware so that it does not obstruct spray arm ro-

tation.

Spray arm nozzles are blocked. Clean the Spray arms.

Filters are soiled. Clean the filters.

Filters are inserted incorrectly and/or not engaged. 1. Insert the filters properly. 2. Engage the filters.

Washing programme selected too weak. Select a more intensive washing programme.

Fault Cause and troubleshooting Removable streaks are present on glasses, glass- ware with a metallic ap- pearance and cutlery.

Amount of rinse aid to be dispensed is set too high. Set the rinse aid system to a lower setting.

No rinse aid has been added. Add rinse aid.

Rust spots on cutlery. Cutlery is not sufficiently rust-resistant. Knife blades are often more severely affected. Use rust-resistant tableware.

Cutlery may also rust if washed together with rusting items. Do not wash rusting items.

Detergent residue is present in the detergent dispenser or the tablet collecting tray.

Spray arms were blocked by tableware so detergent was not rinsed out. C

Manualsnet FAQs

If you want to find out how the Series 4 Bosch works, you can view and download the Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide on the Manualsnet website.

Yes, we have the Quick Instruction Guide for Bosch Series 4 as well as other Bosch manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Quick Instruction Guide should include all the details that are needed to use a Bosch Series 4. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide, simply download the document to your computer. Once downloaded, open the PDF file and print the Bosch Series 4 SMS4HCW40G Dishwasher Quick Instruction Guide as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.