Users Manual for Key Safe
WARNING
Read all instructions before using this safe.
A. Handle B. Key Access C. Key Pad D. Indicator Lights E. Key Drop Slot - Located on the side of the safe
- For security purposes, change the factory default code as soon as possible. Factory default code is 159 and 011223.
-Test registered pin code a few times before closing the safe door.
- Avoid leaving door open and unattended; it will allow unauthorized individuals to reprogram the safe, gaining full access to the safe and its contents.
- Store emergency keys in a secure place; NOT inside of the safe.
- To maximize security and performance of the safe,
Lock
Unlock
See reverse side for more information
GETTING STARTED
Remove emergency keys and other included accessories from packaging.
KEY ACCESS 1. Remove grey key cover located on the safe to expose key hole. 2. Use emergency key and insert into key hole, turn key counter clockwise and turn handle clockwise.
BATTERY
Battery compartment is located on the inside of the door safe.
1. Remove battery compartment cover. 2. Insert four AA alkaline batteries into the battery compartment and restore battery compartment cover.
Note: Do not mix new and old batteries
PIN CODE REGISTRATION
1st Safe Default Pin Code : 159 2nd Safe Default Pin Code : 011223 1. Press * *, then yellow indicator light next to warning will light up. 2. Input current user code that you want to change, and press #. 3. Input your new pin code you want to change it to and press #. 4. Input your new pin code one more time to confirm registration and press #. Yellow light will turn off, meaning code has been registered.
Repeat steps above to change second pin code
TESTING REGISTERED PIN CODE
With safe door open turn handle counter clockwise to extend the bolts. Enter registered pin code and press # safe should unlock. Turn handle clockwise and bolts shall retract; if safe unlocked then registration is complete.
Note: If safe does not unlock then pin code registration was unsuccessful. Please start over with Pin Code Registration.
DELETING PIN CODES / RESETTING SAFE TO FACTORY DEFAULT MODE
Please only reset the safe if Pin Codes are lost or forgotten.
PARTS OF THE SAFE
A
B
E
C
D
1. Open safe and remove screws securing the back cover to the safe.
2. You will see a small button located on the circuit board. 3. Press and hold small button until you see all the lights flash and 2 quick beeps will be heard. 4. All pin codes have been resetted to factory Default Pin Codes.
Note: 1st Safe Default Pin Code : 159 2nd Safe Default Pin Code : 011223
MOUNTING INSTRUCTIONS
The safe may be mounted to a wall. Be aware of the load bearing. Failure to do so can result in personal injury and/or damage to property. Use appropriate tools when performing work and always use eye protection.
- Do not mount the safe without anchoring to the wall. - Find the studs in the wall, at your desired location. Most studs are 16 inches or 24 inches apart. - Check the wall for concealed wires or pipes. - Measure the location of the pre-set drill holes; mark their exact position onto the wall ensuring that the studs or anything else behind will not interfere. - Drill the appropriate size holes for the anchors you are using. - Carefully press the anchor into the holes at this time. - Mount the safe by running screws from inside of the safe and securing to anchors; ensure the safe is mounted securely.
2/20 BC636
2020 BARSKA 855 Towne Center Drive | Pomona, CA 91767
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
test pin code every 6 months.
- Test and make sure the safe works properly before mounting. Once tested, mount the safe before use.