Barska Winbest BE12232 Detector User Manual PDF

Download download
Barska Winbest BE12232 Detector User Manual PDF
Barska Manual Barska Detector Manual Barska Winbest Manual Barska BE12232 Manual Barska Detector User Manual
Pages 1
Year 2013
Language(s)
English en
1 of 1
1 of 1

Summary of Content for Barska Winbest BE12232 Detector User Manual PDF

Page 1

2013 BARSKA 855 Towne Center Drive | Pomona, CA 91767

(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com BC37311/13

Inserting the Battery

Loosen the screw on the battery cover and remove the battery cover. Insert a new 9V battery into the battery compartment and pay attention to the polarity symbols. Replace the battery cover and retighten the screw on the battery compartment.

Operating Instruction

Hold the detector by the handle in a comfortable position. Set the control slide switch from the OFF mode to either of the other modes to turn the metal detector on. The power indictor light will be on and a momentary beep is heard.

Control slide switch functions

Visual and Audio Alert

Visual Alert

To test the detector, pass it over a known area with metal objects and check for the visual and/or audio alarms. It should be tested at regular intervals to ensure correct operation.

Adjusting the Sensitivity

To adjust the sensitivity, locate the sensitivity adjuster and use a small flat bladed screwdriver to rotate the potentiometer located in the hole, rotate screwdriver:

- Clockwise to increase sensitivity

- Counter-clock to decrease sensitivity

Increase sensitivity until both audio and visual alarms are continuously on, and then slightly decrease the sensitivity. Preset sensitivity is at 1.96 inches / 5 cm for a US .25 coin. (Note: Do not adjust the sensitivity higher than necessary as this may cause false alarms)

Low Battery Warning

Replace the battery when either of these situations occur with the metal detector

- If the metal detector is not detecting metal objects over a know area with metal objects

- If audio tone alarms continuously Trouble Shooting

Move to a different search area if

- Alarms when in motion, but is stable in open air, there could be too much metal in the area.

- Alarms when motionless or motion, it could be the result of interference from electronic equipment (as broadcast antennas, power lines etc).

If neither of the above is successful, the sensitivity may be too high and requires adjustment.

A. Red LED Visual Alert B. Search Coil C. Green LED On/Off Indicator D. Control Slide Switch E. Sensitivity Adjuster F. Handle G. Speaker Audio Alert

Handheld Metal Detector

A B

E

D

C

G

H F

H. Battery Compartment and Cover (located under the handle)

Care and Maintenance

- Keep your detector clean and dry.

- Clean detector with damp cloth to maintain its appearance.

- Do not use chemical cleaners.

WINBEST by BARSKA, as manufacturer, warrants this new product to be free of original defects in materials and/or workmanship for the length of time specified by this warranty. This warranty does not include damage caused by abuse, improper handling, installation, maintenance, normal wear-and-tear, unauthorized repairs or modifications and tampering in anyway.

This warranty is limited to the original purchaser and is not transferable. This warranty applies only to products purchased in the United States of America and Canada.

In the event of a defect within 30 days, the consumer must return the defective unit to the WINBEST by BARSKA dealer (the place of purchase) at his/her own expense.

Beyond 30 days, WINBEST by BARSKA products should be sent to the following address for warranty repairs. Products must be packed carefully and sturdily to prevent damage in transit, and returned freight prepaid to:

WINBEST by BARSKA

855 Towne Center Drive Pomona, CA 91767

For additional and updated information please visit www.barska.com

Please email info@barska.com or call 1.888.666.6769 for Return Merchandise Number (RMA#) before any returns. NOTE: All merchandise received without a valid RMA# will be returned to shipper at his/her own expense.

Please include all of the following when returning WINBEST by BARSKA products for service and/or replacement: 1. Please write your complete details (Name, Address, Telephone #, E-mail address, RMA#, etc.) 2. Purchase receipt or Proof of Purchase. (Original/Copy) 3. A brief explanation of the defect 4. A Check/Money Order of $15.00 to cover inspection, shipping and handling *Please allow 6-8 weeks for delivery

This product will either be replaced or repaired at the discretion of the warrantor. If it's a discontinued item, we will replace the product with an equivalent product. Should the repair not be covered by this warranty, an estimate will be sent for your approval. Non-warranty repairs or refurbishing are always provided at a reasonable cost.

WINBEST by BARSKA shal

Manualsnet FAQs

If you want to find out how the Winbest Barska works, you can view and download the Barska Winbest BE12232 Detector User Manual on the Manualsnet website.

Yes, we have the User Manual for Barska Winbest as well as other Barska manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The User Manual should include all the details that are needed to use a Barska Winbest. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Barska Winbest BE12232 Detector User Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Barska Winbest BE12232 Detector User Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Barska Winbest BE12232 Detector User Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Barska Winbest BE12232 Detector User Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Barska Winbest BE12232 Detector User Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.