Apple iMac G5, 17 Inch v4 Replacement Instructions PDF

1 of 13
1 of 13

Summary of Content for Apple iMac G5, 17 Inch v4 Replacement Instructions PDF

034-3247 Rev A

iMac G5, 17-inch (Ambient Light Sensor)

Lower Fan, iMac G5, 17-inch

Replacement Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty.

Note:

Online instructions are available at http://www.apple.com/support/doityourself/.

Tools Required

Use the enclosed tool, or a Phillips #2 screwdriver Flat-blade screwdriver

Part Location

2 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

Important Things to Know

1. Dont remove any screws other than the ones mentioned in this document.

2. Ground yourself when working on the computer. The procedure will show you how to ground yourself.

3. Keep drinks and other liquids away from the area you are working on the iMac.

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

3

Opening the Computer

1. Turn your computer off by choosing Shut down from the Apple (

K

) menu.

2. Disconnect all cables, and unplug the power cord from your computer.

3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of the computer and slowly lay the computer face down as shown.

4 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

4. Locate the three silver case screws circled below. Lift the stand up to locate the middle case screw.

Note:

These screws are captive; they are part of the display/bezel assembly and cannot be removed.

Using the tool provided, or a Phillips #2 screwdriver, loosen the three captive screws. Turn the screws to the left until they stop turning.

Dont force the screws once they stop turning

.

5. Holding the stand, tilt the back cover up and lift it off the computer.

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

5

Removing the Lower Fan

1. Ground yourself before touching anything inside the computer. Touch the metal surface (as shown below) on the inside of the computer to discharge any static electricity.

Warning:

Always discharge static electricity before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk around the room until you have nished installing the part and closed the computer

.

6 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

2. Locate the metal locking clip on the top of the fan housing. Use a at-blade screwdriver to raise up the clip approximately 1/4 inch.

3. Push the metal locking clip all the way back until the fan begins to lift out of the computer.

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

7

4. Disconnect the fan connector on the logic board. Pull on the black connector not the cable.

5. Grab the fan by the sides and wiggle the fan upward. As the fan comes up, the fan will bump into a tab on the front bezel. See the next step.

8 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

6. Push the fan into the computer and at the same time, tilt the fan so that it clears the tab on the bezel.

7. Pull the fan cable through the metal bracket (1) as you pull the fan forward (2).

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

9

Installing the Lower Fan

1. Push the lower fan (1) into the computer, aligning the fan with the metal bracket. Notice the location of the two gray bumps on the right side of the fan. These plastic bumps should be in this position for this step.

Pull the fan cable (2) through the metal bracket.

2. The edge of the fan (circled) has to clear the speaker. Push the fan into the computer until the edge of the fan clears the speaker.

10 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

3. As you push the fan, make sure it clears the white tab on the display bezel.

Important:

Notice the position of the gray bumps on the side of the fan. This is the correct position for this step.

4. Lower the fan into the display bezel. Pull the metal locking clip down onto the fan making sure it secures the fan.

Connect the fan cable to the logic board.

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

11

Closing the Computer

1. Replace the cover so that the slots on the top edge of the cover mate with the tabs on the display housing.

2. Tilt the back cover slightly and align the top edge with the tabs on the housing. Push the two together as you lower the back cover.

12 -

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor)

3. Tighten the three captive case screws by turning them to the right. Dont overtighten the screws.

4. Reconnect the power cord while the computer is face down; then position the computer in the upright position. Turn on the computer.

Lower Fan, iMac G5, 17-inch (Ambient Light Sensor) -

13

Apple Computer, Inc.

2005 Apple Computer, Inc. All rights reserved.

This document is protected under U.S. Copyright Law and International Treaties, and no part of this document may be reproduced in any form without written permission from Apple.

Apple is not responsible for typographical, printing, or inadvertent errors.

Apple Computer, Inc

Manualsnet FAQs

If you want to find out how the 17 inch Apple works, you can view and download the Apple iMac G5, 17 Inch v4 Replacement Instructions on the Manualsnet website.

Yes, we have the Replacement Instructions for Apple 17 inch as well as other Apple manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Replacement Instructions should include all the details that are needed to use a Apple 17 inch. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Apple iMac G5, 17 Inch v4 Replacement Instructions is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Apple iMac G5, 17 Inch v4 Replacement Instructions consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Apple iMac G5, 17 Inch v4 Replacement Instructions free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Apple iMac G5, 17 Inch v4 Replacement Instructions, simply download the document to your computer. Once downloaded, open the PDF file and print the Apple iMac G5, 17 Inch v4 Replacement Instructions as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.