Amcrest AC-2 Baby Monitor Quick Start Guide PDF

1 of 2
1 of 2

Summary of Content for Amcrest AC-2 Baby Monitor Quick Start Guide PDF

Quick Start Guide Connection & Installation

This section provides information about pairing the handset with the camera.

Once powered on, a battery icon with a lightning bolt will display on the upper right-hand of the screen. This indicates the handset is charging. When the handset is completely charged, the battery indicator shown on the screen will be full and you may disconnect it from the charging cable as desired.

Powering on the Camera

Connect the included power adapter to a wall outlet.

Connect the camera to the power adapter.

Slide the ON/OFF switch to the ON position.

Powering on the Handset

Connect the included power adapter to a wall outlet.

Connect the handset to the power adapter.

Press and hold the power button until the handset powers on.

On/O

Press and Hold to Speak

Conguration Settings

Tilt Camera Up

Tilt Camera Down

Pan Camera Right

Pan Camera Left

Indicates if the device is powered on or o.

Indicates the status of the connected cameras. When lit indicates there is no link.

Display

Push to Talk

Menu

Tilt Up

Tilt Down

Pan Right

Pan Left

Power

Link

Icon Description Options

Handset Button Menu

Pairing your Handset & Camera By default, the camera and the handset comes paired and should be ready to use, However, If for any reason pairing needs to be reestablished between the handset and the camera, please Follow these instructions:

Within the handset menu please navigate to the setting icon

Next, navigate to "Add" and press the button located between the standby and buttons on the handset face.

Now, select a channel and press to start the pairing process.

Located under the camera, press and hold the button while the camera is powered on. If the pairing process was completed within the allotted time, you should see an image captured by the camera unit.

Please note that the handset will only pair within 15 seconds. If the camera does not pair within this time you will need to begin the process again.

!

5 Levels

5 Levels

On/OFF

5 Lullabies, All

1 Min, 3 Min, 4 Min

Del, Add, View, Scan

Adjust Voice Detection Sensitivity

1-36 C / 34-97 F

Volume

Screen Brightness

Night Light

Lullaby Music

Sleep Mode Delay

Camera Options

VOX Voice Detection Sensitivity

Current Camera Unit Temperature

Icon Description Options

Menu Icons Overview

On/O

Conrm Selections

Activate Alternative Function

Turn Volume Up

Turn Volume Down

Enable/Disable

Scan Between Cameras Feeds

Power

OK

Alternative Function

Volume Up

Volume Down

Zoom

Camera Scan

Icon Description Options

Alternative Function (Fn) Icons

Device does not turn on: Conrm the camera and monitor unit are both ON (check Power LED indicator). Check that both handset and camera units are charged or plugged into a charger. Battery may be depleted and may need to be recharged or replaced. Check that power adapters are connected correctly.

"Out of Range" displaying on handset unit: Move the handset closer to the camera unit. Register the camera to the handset unit. Reset both units by disconnecting them from battery and electrical power. Wait about 15 seconds then reconnect and pair. Large metallic objects including mirrors, doors, refrigerators, llings cabinets, may also block radio signal if it is between the two units. Signal strength may be reduced when in close proximity to radio or other electrical equipment such as TVs, computers, phones, uorescent light, or dimmer switches. Use of 2.4Hz product such as WiFi routers, Bluetooth systems, or microwave ovens may cause interference. Keep camera and handset units at least 5ft from these items or turn them o.

Reception Interference: The camera and handset units may be too far apart. Move the handset unit closer to the camera unit. The battery power may be too low. Check for interference from other electronic devices. Handset and camera unit may be too close in proximity to large metallic objects causing interference. Use of 2.4Hz product such as WiFi routers, Bluetooth systems, or microwave ovens may cause interference. Keep camera and handset units at least 5ft from these items or turn them o.

High pitched noise from handset unit: Increase the distance between the handset and camera unit. Volume may be too high. Reduce the volume on the handset unit. Camera unit may be too far from the handset unit. Move the camera unit closer to the handset unit. Make sure camera and handset units are placed away from other electrical equipment, such as television, computer, or phone.

Trou

Manualsnet FAQs

If you want to find out how the AC-2 Amcrest works, you can view and download the Amcrest AC-2 Baby Monitor Quick Start Guide on the Manualsnet website.

Yes, we have the Quick Start Guide for Amcrest AC-2 as well as other Amcrest manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Quick Start Guide should include all the details that are needed to use a Amcrest AC-2. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Amcrest AC-2 Baby Monitor Quick Start Guide is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Amcrest AC-2 Baby Monitor Quick Start Guide consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Amcrest AC-2 Baby Monitor Quick Start Guide free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Amcrest AC-2 Baby Monitor Quick Start Guide, simply download the document to your computer. Once downloaded, open the PDF file and print the Amcrest AC-2 Baby Monitor Quick Start Guide as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.