Acura TL Overhead Controls 2010 Sedan Instruction Manual PDF

1 of 3
1 of 3

Summary of Content for Acura TL Overhead Controls 2010 Sedan Instruction Manual PDF

Moonroof

Open: Pull the switch fully back, then release it. The roof will open completely. To stop, briefly push forward on the switch. Close: Push the switch fully forward, then release it. The roof will close completely. To stop, briefly pull back on the switch. Tilt: Push straight up on the switch. The moonroof will tilt completely.

The moonroof can be opened, closed, or tilted using the moonroof control switch.

Tip: To partially open or close the moonroof, lightly move the switch to the first detent and hold it there. Release the switch and the roof will stop in the desired position. Note: The front windows/moonroof can also be opened with the lock cylinder and the remote. See Locks in your owners manual for more information.

Ceiling Lights All the front and rear ceiling lights can be operated both individually, and from the front seats.

ON button: Push to turn on all ceiling lights. OFF button: Push to turn off all ceiling lights. Door button: Push to activate. When activated, all the lights come on when you open any door, unlock the doors with the remote or built-in key, or turn the ignition from ON (II) (or ON MODE) or ACCESSORY (I) (or ACCESSORY MODE), to OFF (or VEHICLE OFF/LOCK MODE). Push each ceiling light button to turn the light on or off. Tip: The indicator in the button is on when it is activated.

Overhead Controls

Courtesy Lights Doors: The courtesy light in each front door comes on when the door is opened, and goes out when the door is closed. Sun visors: The courtesy lights between the sun visors come on when the parking lights are turned on. Tip: You can adust the brightness of the courtesy lights above with the instrument panel brightness control buttons (see Driver Controls). Ignition Switch (without navigation): Comes on when you open the drivers door, then fades around 30 seconds after you close the door. Keyless Access Remote Slot (with navigation): Comes on when you open any door or unlock the drivers door, then fades around 30 seconds after you close or lock the drivers door.

* Check the owners manual for additional information and instructions.

HomeLink The HomeLink Universal Transceiver built into your vehicle can be programmed to operate up to three remote controlled devices around your home, such as garage doors, lighting, or home security systems.

Press and hold the button on the remote and the HomeLink button at the same time. Then, while continu- ing to hold the HomeLink button, press and release the button on the remote every 2 seconds. Does the LED blink at a faster rate within 20 seconds?

Press and hold the HomeLink button again.

Training complete

YESNO

HomeLink indicator flashes for 2 seconds, then remains on.

HomeLink LED remains on.

YESNO

YESNO

Position the remote transmitter you wish to link 13 inches from the HomeLink button you want to program.

1

Press and hold the desired HomeLink button and the button on the remote transmitter you wish to link. Does the HomeLink indicator (LED) blink at a faster rate after about 10 seconds?

2

a The remote has a rolling code. Press the learn button on the remotely controlled device (e.g., garage door opener).

Press the programmed HomeLink button again; the remotely controlled device should operate.

Within 30 seconds, press and hold the programmed HomeLink button for 2 seconds.

a

Press and hold the programmed HomeLink button for a second. Does the device (garage door opener) work?

3

b

4

5

Training a Button

Indicator remains on for about 25 seconds (standard transmitter).

Indicator flashes rapidly for 2 seconds, then remains on for about 23 seconds (rolling code transmitter).

Press and hold the desired HomeLink button until the HomeLink indicator begins to flash slowly.

When the indicator begins to flash slowly, continue to hold the HomeLink button and follow steps 1 4 under Training a Button.

1

2

Retraining a Button

Erasing Codes To erase codes stored in all buttons, press and hold the two outer buttons until the HomeLink indicator begins to flash (about 10 to 20 seconds), then release the buttons.

Manualsnet FAQs

If you want to find out how the Overhead Controls Acura works, you can view and download the Acura TL Overhead Controls 2010 Sedan Instruction Manual on the Manualsnet website.

Yes, we have the Instruction Manual for Acura Overhead Controls as well as other Acura manuals. All you need to do is to use our search bar and find the user manual that you are looking for.

The Instruction Manual should include all the details that are needed to use a Acura Overhead Controls. Full manuals and user guide PDFs can be downloaded from Manualsnet.com.

The best way to navigate the Acura TL Overhead Controls 2010 Sedan Instruction Manual is by checking the Table of Contents at the top of the page where available. This allows you to navigate a manual by jumping to the section you are looking for.

This Acura TL Overhead Controls 2010 Sedan Instruction Manual consists of sections like Table of Contents, to name a few. For easier navigation, use the Table of Contents in the upper left corner.

You can download Acura TL Overhead Controls 2010 Sedan Instruction Manual free of charge simply by clicking the “download” button in the upper right corner of any manuals page. This feature allows you to download any manual in a couple of seconds and is generally in PDF format. You can also save a manual for later by adding it to your saved documents in the user profile.

To be able to print Acura TL Overhead Controls 2010 Sedan Instruction Manual, simply download the document to your computer. Once downloaded, open the PDF file and print the Acura TL Overhead Controls 2010 Sedan Instruction Manual as you would any other document. This can usually be achieved by clicking on “File” and then “Print” from the menu bar.