3jTech EDGE Super Modem Quick Installation Guide PDF

Ver 1.0.0.0

Since 1988

1

Quick Installation Guide for EDGE Super Modem 1. EDGE Super Modem Packing List : Before you start installing EDGE Super Modem, please verify that the package contains the following items:

One Set of EDGE Super Modem 1x Power Adapter 1x 3G Antenna External 3G Antenna with 3M Antenna Cable (Optional) 1x RJ45 Cable Users Manual and this Quick Installation Guide

NOTE: Please notify your sales representative immediately if any items listed above is missing or damaged.

2. Hardware Connection Settings for the EDGE Mode (Please skip this section if you would like to use the Bridge mode connection. For more details about the mode

switching, please jump to Section 4.) 1) Connect PC to LAN port of your EDGE Super Modem using a RJ45 cable. 2) Screw the antenna to 3G ANT SMA connector on your EDGE Super Modem. 3) Make sure the SIM card has inserted to the SIM card slot on your EDGE Super Modem, and

the modem is ready as well. 4) Connect the power cable to the power connector of your EDGE Super Modem.

Ver 1.0.0.0

Since 1988

2

3. Hardware Connection Settings for the Bridge Mode (Please skip this section if you would like to use the EDGE mode connection. For more details about the mode

switching, please jump to Section 4.) 1) Connect PC to LAN port of your EDGE Super Modem using a RJ45 cable. (Note: The LAN port

of the EDGE Super Modem also could be connected to the WAN port of a router/IP-sharing device and

connect PC(s) under this router/IP-sharing device.) 2) Screw the antenna to 3G ANT SMA connector on your EDGE Super Modem. 3) Make sure the SIM card has inserted to the SIM card slot on your EDGE Super Modem, and

the modem is ready as well. 4) Connect the power cable to the power connector of your EDGE Super Modem.

4. Mode Selection between EDGE Mode and Bridge Mode EDGE Super Modem supports two modes in operation. For the correct position of these two switching mode, please refer to the figure below.

Note:

EDGE Mode: Push the switch backward, PC

will get the virtual IP address from 3G Super

Modem.

Bridge Mode: Push the switch frontward, PC

will get the IP address from ISP.

Ver 1.0.0.0

Since 1988

3

5. Software Connection Settings for EDGE Mode Only Before the setup, please confirm that the LAN port of EDGE Super Modem has been connected with the PC via RJ45. Initiate your Internet Explorer and type in http://192.168.8.1 into IE browser to enter the setup page of EDGE Super Modem. Also input admin as the user name as well as the password, and refer to the following sections to set up your EDGE Super Modem:

Modem Settings 1) Once you are in the setup, please select 3G Setting item in Basic Setting section of the

setup.

2) In HSUPA Settings page, please select your desired operation mode upon the SIM card inserted. (Default is 3G + 2G (3G Preferred))

3) Please contact your ISP for the 2G/3G online settings. The user must enter PPP User Name, PPP Password, and Access Point Name (APN) for your EDGE Super Modem.

4) Click on Apply after completing the setup. DDNS Settings ( if necessary)

1) Go to the http://www.dyndns.com/ or http://www.no-ip.com/ website to apply for a free DDNS account, DDNS password and DDNS domain name for your EDGE Super Modem.

2) Select DDNS Setting item in Basic Setting section of the setup. Fill in DDNS account, DDNS password and DDNS domain name you had applied accordingly. Thus, you will be allowed to access your EDGE Super Modem with this domain name when its IP address has been changed.

3) Click on Apply after completing the setup.

Please ask your ISP for

required information

Ver 1.0.0.0

Since 1988

4

6. Restore Factory Default Settings EDGE Super Modem provides a Reset button that will be easy for users to reset EDGE Super Modem to default. The button is located at the front panel of EDGE Super Modem (See the figure below). Reset steps are as follows:

1) Plug in the power cable. 2) Wait about 40~60 seconds to have the system powered on. 3) Press the <